PCIe 5.0 Hyper Riser od HYTE, 20 cm, zelená/biela (ACC-HYTE-PCIE50-MM)

HYTE PCIe 5.0 Hyper Riser is a 20 cm vertical riser cable in green and white designed to extend and reposition PCIe cards inside a PC chassis. The cable supports PCIe 5.0 bandwidth and lane configurations, enabling relocation of a GPU or other expansion cards without modifying the motherboard layout. Supplied as a plug-and-play accessory, the riser allows builders and modders to create showcase layouts, improve internal airflow, and achieve flexible component placement in compact or custom enclosures.

Advantages

The riser provides full support for PCIe 5.0 signaling over a short 20 cm cable, delivering low-latency, high-bandwidth connectivity for graphics cards and other expansion devices. Its flexible design and reinforced connectors simplify installation and reduce mechanical stress on the motherboard slot. The green-and-white aesthetic matches themed builds and offers a clean visual accent for vertically mounted cards. As a plug-and-play accessory, it requires no additional configuration and is compatible with standard PCIe slot implementations.

Suitable for

• Custom PC builds with vertical GPU mounting or non-standard card placement
• Small form factor and compact chassis where card relocation is necessary
• Enthusiast showcase systems and modded cases that emphasize component visibility
• Systems seeking improved internal airflow by repositioning large expansion cards

Key specifications

• Interface: PCI Express 5.0 compatible
• Cable length: 20 cm
• Connector orientation: vertical riser configuration for GPU or expansion cards
• Signal support: high-bandwidth, low-latency PCIe lanes suitable for modern graphics and expansion cards
• Build: flexible cable with reinforced end connectors and aesthetic green/white sleeving

How to use

Install the riser by aligning and seating one end into the motherboard PCIe slot and the other into the PCIe card’s connector, ensuring secure mating at both ends. Route the cable within the chassis to avoid sharp bends or pinching, and secure it with existing case tie points or clips to minimize movement. After physical installation, power on the system; the card should be recognized by the platform as if directly installed in the slot. No special drivers or firmware changes are typically required for operation with compatible PCIe 5.0 systems.

Recommendations

For reliable performance, use the riser in systems that support PCIe 5.0 or equivalent backward-compatible implementations and avoid excessive cable bending or compression. Ensure adequate case airflow around relocated cards and verify mechanical clearance and retention for long or heavy GPUs. When assembling, handle connectors by their reinforced ends and confirm firm seating before system power-up.