120 mm ventilátor skrine Jonsbo HF2-120 biely — Reverse Blade, PWM, ARGB

The Jonsbo HF2-120 White is a 120mm case fan with a reverse blade design, PWM speed control and addressable RGB (ARGB) lighting. It is intended for use in PC systems where compact 120mm mounting compatibility, adjustable fan speed and synchronized lighting effects are required. The fan's white frame and blades provide a neutral aesthetic that integrates with a wide range of system builds while the reverse blade profile is engineered to influence airflow direction and pressure characteristics for case ventilation.

Advantages

The reverse blade geometry improves airflow distribution and can reduce turbulent noise compared with standard blade shapes at similar rotational speeds. PWM control enables automatic speed adjustment based on motherboard or fan controller signals, allowing lower noise levels during idle and higher airflow under load. Addressable RGB lighting supports per-LED lighting effects and can be synchronized with compatible ARGB headers for coordinated system illumination. The 120mm form factor ensures broad compatibility with typical case fan mounts and radiator locations.

Suitable for

• General PC case ventilation in desktop and small-form-factor builds
• Supplementary airflow for CPU and GPU cooling
• Systems where adjustable fan speed and ARGB synchronization are desired
• Upgrades to replace older or noisy 120mm fans while adding lighting

Key specifications

• Frame size: 120mm standard mounting
• Blade design: reverse/optimized blade profile for airflow and pressure balance
• Control: PWM speed control compatible with standard 4-pin fan headers
• Lighting: addressable RGB (ARGB) per-LED control via 3-pin 5V ARGB header
• Electrical: low-voltage DC operation typical for 120mm case fans
• Bearings and expected lifetime: designed for continuous PC use with standard bearing technology

How to use

Install the Jonsbo HF2-120 White into any standard 120mm fan mount inside the PC case, aligning screw holes and using the supplied or case screws to secure the fan. Connect the 4-pin PWM power connector to a motherboard fan header or compatible fan controller to allow automatic speed control. Connect the 3-pin 5V ARGB cable to a compatible ARGB header on the motherboard or ARGB controller to enable lighting effects and synchronization. Ensure the fan orientation matches desired airflow direction for intake or exhaust and verify BIOS or software fan curves for PWM response.

Recommendations

For optimal results, configure PWM curves in motherboard firmware or software to balance noise and cooling, and verify ARGB voltage and pinout compatibility before connecting to a controller. Periodically clean the fan blades and frame to maintain airflow and cooling performance.