Anti-Wobble puzdro od ergonomic solutions SP1-P22112-02 — plastové Anti-Wobble puzdro

The Anti-Wobble Sleeve by ergonomic solutions SP1-P22112-02 is a plastic anti-wobble sleeve designed to reduce play and stabilize fittings and components in assemblies where lateral movement or looseness affects performance. This accessory fits around shafts, fasteners, or inside housings to improve alignment, limit undesired motion and support consistent mechanical contact. The sleeve is intended for applications where simple, durable stabilization is needed without complex redesign of existing parts.

Advantages

The sleeve offers a lightweight, corrosion-resistant solution that dampens wobble and reduces wear on mating parts. Its plastic construction provides a low-friction interface, helping maintain smooth operation while isolating vibrations. Installation is typically non-destructive and reversible, allowing maintenance or replacement without modifying the host component. The design supports repeatable alignment and contributes to longer service life of assemblies by minimizing micro-movements that lead to fatigue.

Suitable for

• Reducing play in shaft-to-bearing interfaces
• Stabilizing connectors and fastener assemblies
• Minimizing vibration in small mechanical fixtures
• Aligning components in jigs, fixtures, and housings

Key specifications

• Material: durable engineering-grade plastic suitable for mechanical wear reduction
• Function: anti-wobble / play reduction and alignment support
• Compatibility: designed to fit common shaft or housing geometries where a sleeve can be applied
• Mechanical properties: low friction surface to reduce wear between mating parts
• Maintenance: removable and replaceable without permanent modification to assemblies

How to use

Select a sleeve size that matches the shaft or housing dimensions and slide the Anti-Wobble Sleeve into position so it contacts the mating surfaces uniformly. Ensure the sleeve seats fully against shoulders or stops where present to achieve consistent alignment. In assemblies with axial loads, verify that the sleeve is oriented as recommended by the system design so that it supports radial stabilization without interfering with intended movement. After installation, check for smooth rotation or sliding and confirm that play has been reduced to acceptable levels.

Recommendations

For reliable performance, inspect mating surfaces for debris or burrs before installation and replace the sleeve if excessive wear or deformation appears. Avoid exposing the sleeve to chemicals or temperatures outside the material limits and consult equipment tolerances to ensure the sleeve thickness and compliance meet clearance requirements.