Barrow Multi-Link adaptér 90° 12mm TWT90KNS-K12 w – uhlový konektor pre Multi-Link rúrky

Barrow Multi-Link Adapter 90° 12mm TWT90KNS-K12 w is an angled connector engineered to create a fixed 90-degree joint between 12 mm multi-link tubing segments. It is intended for compact routing of cooling or fluid lines where a right-angle connection is required. The adapter provides a stable mechanical junction that reduces stress on tubing at bends and helps maintain a tidy, space-saving layout in PC water-cooling loops and similar systems.

Advantages

The adapter offers a precise 90-degree angle and a design compatible with 12 mm multi-link tubing, allowing for consistent alignment and secure joins. Its fixed-angle construction eliminates the need for manual bending of tubing at tight corners, reducing the risk of kinks and uneven flow. The component contributes to a neater installation and can improve long-term reliability by minimizing mechanical strain at critical turns.

Suitable for

• PC water-cooling loops with 12 mm multi-link tubing
• Compact fluid routing in custom cooling setups
• Applications requiring a stable fixed 90° joint for 12 mm tubing
• Systems where reduced bend stress and tidy cable/tube management are desired

Key specifications

• Angle: fixed 90°
• Tubing compatibility: 12 mm multi-link tubing
• Function: mechanical connector for right-angle joints in fluid lines
• Typical use environment: PC cooling loops and small fluid routing systems

How to use

Fit the adapter between two sections of 12 mm multi-link tubing by inserting each tubing end over the corresponding connection point until fully seated. Ensure that tubing is clean and free of debris before assembly to maintain a secure seal. Verify alignment so the fixed 90° orientation matches the intended routing path, and check that all connections are firm before pressurizing or filling the system. If your setup uses clamps or retention fittings, apply them according to the tubing manufacturer’s recommendations.

Recommendations

Inspect the adapter and tubing periodically for wear, deformation, or leaks, especially after initial installation and system pressurization. Avoid forcing incompatible tube sizes onto the adapter and follow manufacturer guidance for compatible multi-link tubing materials and clamping methods.