CBO transceiver SFP-10G-RJ45-80M 10 Gbit/s SFP+ RJ45 medený modul, až do 80 m

The CBO Transceiver SFP-10G-RJ45-80M is a 10 Gbps SFP+ RJ45 copper module engineered for short-range 10 Gigabit Ethernet links over standard copper cabling. Designed to fit SFP+ ports, this transceiver supports reliable connectivity between switches, servers and storage devices within a typical server room or data center topologies. The module offers a copper-based alternative where fiber is not required or where existing copper infrastructure is preferred, providing up to 80 meters reach at 10 Gbps throughput.

Advantages

This SFP+ RJ45 copper transceiver delivers 10 Gbps performance with low-latency operation suitable for high-throughput environments. Its compact SFP+ form factor enables simple hot-plug installation into compatible ports and conserves transceiver slot space compared to larger modules. The use of standard RJ45 copper cabling reduces the need for fiber patching and can lower deployment complexity in short-reach scenarios. The module is compatible with common network devices that accept SFP+ copper interfaces and supports auto-negotiation for straightforward link setup.

Suitable for

• Short-range 10G uplinks between switches and aggregation devices
• Server-to-switch 10G connections in racks and server rooms
• Storage network interconnects requiring 10 Gbps copper links
• Environments using existing Cat6/Cat6a copper cabling for 10G

Key specifications

• Data rate: 10 Gbps (SFP+)
• Interface: RJ45 (copper)
• Maximum reach: up to 80 meters over appropriate copper cabling
• Form factor: SFP+ hot-pluggable module
• Typical use: short-reach 10 Gigabit Ethernet links

How to use

Insert the SFP-10G-RJ45-80M module into an available SFP+ slot on a compatible switch, server NIC or storage device until it clicks into place. Connect a suitable RJ45 copper cable to the module and the remote device, ensuring the cable category meets the 10G requirements for the target distance. After connection, verify link status and speed through the device management interface and confirm auto-negotiation or manually configure the port settings if necessary. For removal, power down the port if required by the host device, depress the module latch and carefully pull the transceiver out of the slot.

Recommendations

Use high-quality Cat6a or equivalent copper cabling to achieve reliable 10 Gbps performance up to the specified 80 m reach, and avoid running cables near sources of electromagnetic interference. Confirm compatibility with the host device's SFP+ port and firmware; consult the device vendor for supported transceiver lists if needed.