SFP+ aktívny optický kábel CBO pre Zyxel SFP-AOC-10G-3M 10G 3 m

The SFP+ Active Optical Cable CBO for Zyxel SFP-AOC-10G-3M 10G 3 m is an integrated fiber interconnect that delivers a 10 Gbps SFP+ link over a 3‑meter optical cable. Designed for direct connections between switches, servers and storage devices, this Active Optical Cable combines transceiver and cable into a single assembly to simplify short-distance high-speed networking in racks and data-center aisles.

Advantages

This SFP+ AOC provides native 10 Gbps throughput with low latency and reduced signal loss compared with copper at equivalent distances. By integrating the optical transceivers into the cable ends, it removes the need for separate SFP+ modules and patch cords, reducing component count and simplifying inventory. The 3 m length is optimized for rack-to-rack and short-span connections, offering reliable electrical isolation and immunity to electromagnetic interference typical in dense server environments.

Suitable for

• Rack-to-rack 10 Gbps links in data centres
• Direct server-to-switch or switch-to-switch connections
• Short-distance uplinks and aggregation in network closets
• High-density switch deployments where cable management and EMI mitigation are important

Key specifications

• Interface: SFP+ form factor, hot‑pluggable
• Data rate: 10 Gbps (per link)
• Cable type: Active optical cable with integrated transceivers
• Length: 3 metres
• Transmission medium: Multimode/singlemode optical fibre (integrated AOC design)
• Power consumption: Low-power SFP+ AOC typical profile
• Compatibility: Designed for SFP+ ports supporting 10 Gbps links and compatible with Zyxel SFP-AOC-10G-3M form-factor implementations

How to use

Install the Active Optical Cable by inserting each SFP+ connector into the corresponding SFP+ port on the devices to be connected. Ensure the host devices support 10 Gbps SFP+ connections and are powered off or the ports are inactive during insertion for safe handling if recommended by the equipment vendor. Once seated, enable or verify the 10 G link on both ends via the device management interface; link negotiation and channel status indicators should confirm an operational connection. For removal, power down or disable the port if required, then press the connector latch and pull the module straight out to avoid damaging the socket.

Recommendations

Use this 3 m AOC for short-span connections inside racks and between adjacent racks. Avoid sharp bends or kinks in the optical cable, maintain the minimum bend radius specified by the manufacturer, and keep the connector endfaces clean. For optimal performance, ensure firmware and driver compatibility on both connecting devices and verify link parameters after installation.