Transceiver CBO SFP-10G-RJ45 Copper 10G pre Gigamon-kompatibilné SFP+ porty

The Transceiver CBO SFP-10G-RJ45 Copper 10G for Gigamon-compatible SFP+ ports is a copper SFP+ module that provides 10 Gigabit Ethernet connectivity over standard RJ45 copper cabling. Intended for insertion into SFP+ slots of Gigamon-compatible switches and monitoring appliances, the module supports short-distance 10G links using Cat6, Cat6a or Cat7 cables. It is suitable where copper cabling is preferred for cost, convenience or existing infrastructure considerations and where 10G speeds are required for aggregation, uplinks or traffic monitoring.

Advantages

This SFP+ copper transceiver offers native 10G throughput with backward-compatible RJ45 interface, enabling straightforward integration into existing copper-based network segments without fiber conversion. Its SFP+ form factor allows hot-pluggable installation in compatible switch and appliance ports, reducing downtime during upgrades. The module supports commonly used Ethernet features at line rate over short-reach copper cable, providing a practical choice for uplink, aggregation, and monitoring scenarios where fiber optics are unnecessary or impractical.

Suitable for

• 10 Gigabit uplinks between switches and aggregation points over copper cabling
• Network monitoring and packet broker connections in Gigamon-compatible appliances
• Short-reach data center links and server connections using Cat6/Cat6a/Cat7
• Environments where fiber is not available or where copper cabling is already deployed

Key specifications

• Interface: SFP+ form factor with RJ45 copper connector
• Data rate: 10 Gigabit Ethernet (10GbE)
• Supported cabling: Cat6, Cat6a, Cat7 copper cable (short-reach)
• Reach: short-distance 10G links (dependent on cable category and environment)
• Compatibility: designed for use in SFP+ ports of Gigamon-compatible switches and devices
• Installation: hot-pluggable module for easy replacement or upgrade

How to use

Insert the transceiver into a compatible SFP+ slot on a Gigamon-compatible switch or monitoring device until it clicks into place. Connect an appropriate RJ45 copper cable (Cat6/Cat6a/Cat7) between the module and the corresponding network port. Ensure both ends are secured and verify the link status on the network device. Configure interface settings on the switch or appliance as required for 10GbE operation and monitoring or aggregation tasks. When removing the module, power down or follow hot-swap procedures recommended by the host device to avoid data disruption if applicable.

Recommendations

Use high-quality Cat6a or Cat7 cabling for better margin and longer short-reach performance at 10G. Confirm compatibility with the specific Gigamon-compatible host device and firmware version before deployment. For monitoring and aggregation, place the module in ports designated for traffic visibility to ensure accurate packet capture and minimal interference with production links.