C.K Tools T3115 070 betónový vrták 7 mm x 105 mm s 1/4" šesťhrannou stopkou

Drilling into stone, masonry or concrete with a standard twist bit quickly dulls the cutting edge and can overheat the tool. The C.K Tools T3115 070 masonry drill bit solves this by pairing a carbide tip with a tough 40CR steel body, so you can bore clean holes in hard materials without destroying the bit.

Who is it for

Electricians, plumbers, HVAC technicians and serious DIYers who need to anchor into brick, block or stone. The 1/4" hex shank makes it especially useful for cordless impact drivers and quick-change chucks, letting you swap bits in seconds without a key.

Main features

• 7 mm diameter for common wall plugs and anchors
• Carbide (Hartmetall) tip stays sharp longer in abrasive materials
• 40CR steel body resists bending and breakage under load
• Spiral flute design clears dust efficiently for faster drilling
• 1/4" (6.3 mm) hex shank fits impact drivers and standard drill chucks
• 105 mm overall length reaches through plaster and into the substrate

Specifications

• Drill bit type: Masonry drill bit
• Diameter: 7 mm
• Overall length: 105 mm
• Shank type: Hexagonal
• Shank size: 1/4" (6.3 mm)
• Tip material: Carbide
• Body material: 40CR steel
• Application materials: Stone, masonry, concrete, brick
• Pack quantity: 1 piece

Tips

For best results in hard concrete, use a hammer drill setting if available. Keep the bit cool by withdrawing it periodically to clear dust, and avoid excessive pressure that can overheat the carbide tip.