Doska plošných spojov nabíjačky Charge Amps HALO PCBA ASSEMBLED DLED CA-100632

Replacement assembled printed circuit board (PCBA) specifically designed for Charge Amps HALO charging equipment. This assembled DLED PCBA restores the internal electronics of HALO units and is intended for repair and refurbishment tasks. The component is supplied ready-assembled, enabling qualified technicians and service centres to replace a faulty board and return the charger to operational condition without replacing the entire device.

Advantages

The assembled PCBA is delivered fully populated and tested for basic connectivity, reducing time spent on component-level soldering or assembly. Using a direct replacement board preserves the original device design, maintains compatibility with existing HALO housings and connectors, and reduces overall repair cost compared with full unit replacement. The product supports more efficient servicing workflows and shorter turnaround times in maintenance operations.

Suitable for

• Repair and refurbishment of Charge Amps HALO charging stations
• Service centre component replacement to restore device functionality
• Technician-led diagnostics when board-level faults are identified
• Maintenance programs aiming to extend the service life of HALO units

Key specifications

• Form: fully assembled printed circuit board (PCBA) with DLED components
• Compatibility: designed for use in Charge Amps HALO charging equipment
• Function: replacement control and LED driver circuitry for HALO units
• Mounting: PCB footprint and connector layout matching original HALO internal assembly
• Quality: supplied populated with surface-mount and through-hole components as required for original functionality

How to use

Only trained service personnel should perform the replacement. Disconnect mains power and isolate the charger before opening the enclosure. Remove the existing PCB following the manufacturer's disassembly procedure, noting connector positions and any mechanical fasteners. Fit the assembled PCBA into the original mounting location, reconnect all internal connectors ensuring secure seating, and reassemble the housing. Power up the unit and perform functional checks and diagnostics to confirm correct operation of charging functions and LED indicators.

Recommendations

Use appropriate electrostatic discharge (ESD) precautions during handling and replacement to avoid damage to sensitive components. Verify firmware and configuration compatibility after installation; if the unit requires software updates or calibration, follow Charge Amps service instructions. Retain replaced boards for fault analysis when possible and ensure disposal follows local electronic waste regulations.