Fixácia Kyocera FK-8360 (MPN 302XD93023) — náhradná fixačná jednotka pre tlačiarne Kyocera

Fuser unit Kyocera FK-8360 is a replacement fuser assembly compatible with Kyocera laser printers. It secures toner particles to paper by applying the required heat and pressure during the printing process. Replacing the fuser restores proper toner bonding, reduces smudging, and helps prevent paper jams and fusing errors that occur when the original unit reaches the end of its service life.

Advantages

The fuser unit is built to maintain consistent temperature and pressure across the paper path to ensure uniform prints and reliable operation. Replacing a worn fuser reduces visible print defects such as streaks, ghosting, or areas of loose toner, and contributes to stable sheet handling. The assembly is designed for straightforward installation in compatible Kyocera models and restores the printer’s fusing function without requiring additional adjustments.

Suitable for

• Replacing a worn or failed fuser to restore proper toner adhesion
• Eliminating smudged or smeared output caused by insufficient fusing
• Resolving recurring paper jams originating in the fuser area
• Maintenance when the printer reports fuser end-of-life or fusing errors

Key specifications

• Function: Hot-roll fusing assembly that bonds toner to paper using heat and pressure
• Compatibility: Designed for use with specified Kyocera laser printer models that accept this type of fuser unit
• Components: Heating roller, pressure roller, thermistor/temperature sensor, pressure mechanism and housing for integration into the printer
• Performance: Restores correct fusing temperature range and consistent pressure for reliable print quality
• Physical: Standard service-replacement size and connector interface for direct fit in compatible printers

How to use

Power off the printer and allow the existing fuser to cool before attempting replacement. Follow the printer manufacturer’s service instructions to access and remove the old fuser assembly, taking care to disconnect any connectors and fasteners as indicated. Install the FK-8360 replacement unit by seating it into the printer chassis, reconnecting electrical connectors, and securing retaining screws or clips. After installation, power on the printer and print a test page to confirm correct fusing and alignment.

Recommendations

Use genuine or compatible replacement fusers specified for your Kyocera model and follow safe handling guidelines: allow the unit to cool before touching, avoid contacting the heating surface, and dispose of the removed fuser according to local electronic waste regulations. If print defects persist after replacement, run printer maintenance routines and verify firmware and driver settings match the printer configuration.