Kábel motora osi Y Flashforge 40000356001 pre 3D tlačiareň Creator3

Replacement Y-axis motor cable for the Flashforge Creator3 (MPN 40000356001). This OEM cable is designed to connect the Y-axis stepper motor to the printer electronics, providing correct signal and power transmission for reliable motion control. Intended as a direct replacement for the original part, it restores proper Y-axis operation during repair or routine maintenance of Creator3 series printers.

Advantages

The cable is an original Flashforge part (40000356001), manufactured to match the Creator3 wiring and connector specifications. Using this replacement cable helps maintain factory-level compatibility and signal integrity, reduces installation uncertainty, and shortens downtime when repairing the Y-axis stepper motor connection.

Suitable for

• Repairing a faulty or damaged Y-axis stepper motor cable on Flashforge Creator3 printers
• Routine maintenance requiring replacement of worn wiring for the Y-axis
• Restoring proper motion control after connector or cable failure in Creator3 series

Key specifications

• Manufacturer: Flashforge
• MPN: 40000356001
• EAN: 6971940402091
• Compatibility: Flashforge Creator3 series
• Function: Y-axis stepper motor cable for signal and power transmission

How to use

Power off and unplug the printer before starting. Remove access panels as required to reach the Y-axis motor and controller board. Disconnect the old Y-axis cable from both the stepper motor and the electronics, noting connector orientation. Install the replacement cable (40000356001) by seating connectors fully and securing any routing clips or cable ties. Reassemble panels, power on the printer, and verify Y-axis movement and homing before resuming prints.

Recommendations

Use only when the printer is powered down and follow ESD precautions. Verify connector alignment and routing to avoid pin damage or interference with moving parts. If unsure about disassembly, consult Flashforge service documentation or a qualified technician.