Kábel pre filament box pre Flashforge Guider 3 Plus (MPN 40001922001) — príslušenstvo pre podávanie filamentu

The Filament Box Cable for Flashforge Guider 3 Plus is a replacement feed and communication cable designed to connect the external Filament Box to the Guider 3 Plus 3D printer. It restores the electrical and signal link between the filament storage unit and the printer, enabling filament feed and sensor data transmission required for reliable extrusion control and automatic filament detection. The cable is intended for use during routine maintenance, repair of damaged wiring, or as a spare part to minimize downtime.

Advantages

This replacement cable provides a direct, OEM-compatible connection that maintains original functionality of the Filament Box and printer interface. It supports reliable filament transfer by carrying both power and sensor signals, helping to prevent missed filament detection or feed interruptions. Using a correct replacement cable reduces troubleshooting time and helps ensure consistent print runs without introducing compatibility issues.

Suitable for

• Repairing a damaged or faulty Filament Box connection on the Flashforge Guider 3 Plus
• Replacing a lost or worn cable during regular maintenance
• Keeping as a spare part to minimize printer downtime in production or workshop environments
• Ensuring proper filament feed and sensor communication for uninterrupted prints

Key specifications

• Function: filament feed and sensor signal transmission between Filament Box and printer
• Compatibility: designed for use with the Flashforge Guider 3 Plus Filament Box system
• Connection type: multi-conductor cable with matching connectors for Filament Box and printer interface
• Cable role: carries power and digital/analog sensor signals required for filament detection and drive
• Use environment: indoor use within typical desktop or workshop 3D printing setups

How to use

Power off the printer and disconnect mains supply before replacing the cable. Remove the Filament Box cover or access panel if required, then disconnect the existing cable from both the Filament Box and the printer interface connectors. Align the replacement cable connectors with the corresponding sockets on the Filament Box and the Guider 3 Plus, and push them in until they seat securely. Ensure routing avoids sharp bends and contact with moving parts. Reassemble any panels, restore power, and perform a filament feed test or sensor check to confirm correct installation.

Recommendations

Handle the cable connector ends carefully and avoid pulling on the cable jacket when disconnecting; inspect connectors for debris or damage before installation. Use the replacement cable that matches the Filament Box and Guider 3 Plus interface to maintain proper sensor and feed function. If intermittent detection or feed issues persist after replacement, verify connector seating, check for firmware updates, and consult official service documentation or support.