Náhradná HEPA jednotka s kefovým valcom pre Tineco S7 / S6 séria (MPN 26871)

Replacement HEPA assembly with brush roller designed for use in compatible cordless vacuum cleaners of the Tineco S7 and S6 series. This combined service part integrates a HEPA filtration module and a rotating brush roller to capture fine dust, pet hair and larger debris in a single unit. It is intended for routine maintenance and part replacement to restore the vacuum's cleaning performance and maintain filtration efficiency for home environments.

Advantages

The combined HEPA module and brush roller simplifies maintenance by replacing two wear components at once, helping to reduce downtime and ensure consistent suction and filtration. The HEPA element captures fine particles and allergens, while the rotating brush loosens embedded dust and hair from carpets and hard floors. The unit is shaped to match the vacuum's head assembly, ensuring correct fit and alignment for optimal cleaning coverage.

Suitable for

• Routine replacement of worn brush rollers and filters in compatible Tineco S7 / S6 series vacuum heads
• Homes with pets where hair accumulation on floors and carpets is frequent
• Maintaining indoor air quality by removing fine dust and allergens during vacuuming
• Restoring cleaning performance after prolonged use or heavy debris pickup

Key specifications

• Component type: Combined HEPA filtration module and rotating brush roller
• Filtration: HEPA-grade particle capture suitable for fine dust and allergens
• Brush type: Rotating bristle roller designed for carpets and hard floors
• Compatibility: Designed to fit the cleaning head geometry of specified Tineco S7 and S6 series models
• Material: Durable plastic housing with fibrous HEPA media and synthetic brush bristles
• Maintenance interval: Recommended periodic replacement to preserve suction and filtration performance (interval depends on usage and debris load)

How to use

Power off and remove the vacuum head according to the appliance user manual before attempting replacement. Unlock and detach the existing brush roller and filter module from the head assembly, then insert the replacement HEPA assembly with brush roller ensuring it snaps into place and aligns with the drive and airflow channels. Reassemble the vacuum head, check that the roller spins freely, and perform a short test run to confirm correct installation and suction performance.

Recommendations

Inspect the brush roller and HEPA element regularly for hair entanglement and heavy dust build-up. Clean visible debris from the roller and external housing between replacements to maintain airflow; replace the combined unit when the filter shows permanent discoloration, excessive clogging, or when cleaning performance declines despite basic maintenance.