Napájací kábel Omnitronic studený prístroj konektor 3x1,5 mm², 10 m, čierny

Omnitronic power cable with cold appliance (IEC) connector, 3x1.5 mm² conductor configuration and 10 m length in black. Designed to supply mains power to audio, DJ and AV equipment with compatible IEC inlet, this cable offers a balance of flexibility and conductor cross-section for routine stage, studio and installation use. The molded IEC connector and robust outer sheath are intended for repeated connection cycles and routing in event and fixed-install environments.

Advantages

The cable combines a common IEC cold appliance connector with three-core 1.5 mm² conductors to provide reliable mains delivery for equipment that does not require heavy-duty power conductors. Its 10 m length allows flexible placement between mains outlets and devices while the black outer sheath reduces visual impact in professional setups. Flexible insulation and molded connector ends reduce strain on contact points and facilitate easy handling during setup and teardown.

Suitable for

Key specifications

How to use

Ensure that the connected equipment has a compatible IEC inlet and that the mains voltage and device ratings match local supply standards. Insert the IEC connector firmly into the equipment inlet until it seats, and connect the plug end to a properly rated mains outlet or distribution unit. Route the cable to avoid sharp edges, heat sources and trip hazards; use cable ties or clips where appropriate to secure runs. Do not overload the cable beyond the current rating of 1.5 mm² conductors for continuous high-power devices.

Recommendations

Inspect the cable and connectors visually before each use for signs of damage, exposed conductors, or loose contacts. For permanent or outdoor installations, select a cable and protective routing that meet local electrical codes and environmental requirements. Replace the cable if any damage, excessive wear or intermittent connections are observed.