Rázový uťahovák Bosch GDX 18V-200 Professional, 18V, 184x224x96 mm

The Bosch GDX 18V-200 Professional is a compact, brushless impact driver with a 2‑in‑1 tool holder combining a 1/4" internal hex and a 1/2" square drive. With an 18 V battery supply and dimensions of 184 x 224 x 96 mm, the tool delivers up to 200 Nm tightening torque and 350 Nm breakaway torque while maintaining long lifetime and good battery runtime. It is compatible with the Bosch Professional 18 V battery system and includes Electronic Cell Protection (ECP), an integrated LED work light and a belt clip.

Advantages

The brushless motor provides high performance and extended service life while improving energy efficiency. The unique 2‑in‑1 holder increases flexibility by allowing fast switching between bits and sockets without adapters. A variable speed trigger gives precise control over speed and torque for different fastening tasks. Built-in features such as ECP, LED illumination and a belt clip enhance usability on job sites.

Suitable for

• Tightening and removing screws and bolts (recommended thread sizes M6–M16)
• Work in sheet metal, structural metal and wood
• Professional assembly, maintenance and repair tasks requiring high torque

Key specifications

• Voltage: 18 V
• Tightening torque: 200 Nm
• Breakaway torque: 350 Nm
• Tool holder: 1/4" internal hex + 1/2" square drive (2‑in‑1)
• Dimensions: 184 x 224 x 96 mm
• Motor: Brushless
• Compatibility: Bosch Professional 18 V battery system
• Additional: Electronic Cell Protection (ECP), LED light, belt clip

How to use

Install a charged Bosch 18 V battery, select the appropriate bit or socket using the 2‑in‑1 holder and secure it. Use the variable speed trigger to control rotation speed and apply the required torque; start at lower speed for initial engagement and increase as needed. For removal, use reverse direction. Ensure the LED light is used to illuminate the work area for accurate positioning.

Recommendations

For best results, use compatible Bosch Professional 18 V batteries and chargers, select correct bit and socket sizes for the fastener (M6–M16), and allow the brushless motor to cool under heavy load. Regularly check and clean the holder and maintain batteries according to manufacturer's instructions.