Reproduktorový kábel ShiverPeaks S/CONN 0,75 mm² (24x0,2 CCA) červený/čierny 25 m

ShiverPeaks S/CONN 0.75 mm² speaker cable is a twin-core audio cable with a conductor made from 24×0.2 mm copper-clad aluminium (CCA). Housed in a red/black sheathing and supplied in a 25 m length, this cable is suitable for connecting loudspeakers to amplifiers or receivers where a compact, lightweight conductor is appropriate. The cable is intended for installations with moderate power demands and typical home audio signal levels, including in-wall routing where flexibility and reduced weight are desirable.

Advantages

The cable combines a slim cross-section with consistent conductor geometry to provide predictable impedance and signal transmission across typical home audio frequencies. Its twin-core red/black sheathing simplifies polarity identification during installation. The CCA conductor offers a lower weight and lower cost alternative to pure copper while maintaining acceptable electrical performance for many consumer audio applications. The 25 m length allows for longer runs without intermediate joins, useful in multiroom or whole-house layouts.

Suitable for

• Connecting bookshelf or floorstanding speakers to home amplifiers and receivers
• Multiroom audio runs where moderate power transfer is required
• In-wall or underfloor routing in residential installations (where local codes permit)
• Temporary or permanent installations in home theater setups

Key specifications

• Conductor cross-sectional area: 0.75 mm²
• Conductor construction: 24 strands × 0.2 mm copper-clad aluminium (CCA)
• Cable type: twin-core speaker cable with red and black polarity cores
• Length: 25 m
• Sheath color: red/black
• Intended use: low- to moderate-power audio signal transmission

How to use

Route the cable from the amplifier or receiver to the loudspeaker, maintaining correct polarity by matching the red conductor to the positive terminal and the black conductor to the negative terminal at both ends. Strip an appropriate length of insulation to expose the strands, twist or tin as needed for the chosen connector type, and make secure connections to binding posts, spring clips or terminal blocks. Avoid tight bends and sharp kinks; secure the cable at intervals to prevent strain on terminations. For in-wall installations, verify local building codes and use appropriate conduit or rated products where required.

Recommendations

For optimal performance, keep cable runs as short as practicable for the given layout and avoid routing alongside mains power cables to reduce potential interference. For high-power amplifier systems or very long runs, consider using a larger cross-section pure copper speaker cable to reduce resistive losses.