RGB LED pásik Lamptron FlexLight Multi s infračerveným diaľkovým ovládačom, dĺžka 3 m

Lamptron FlexLight Multi is a 3 m RGB LED strip kit designed to add multicolor illumination to PC cases, desks, shelves and ambient room setups. The kit includes an addressable RGB LED strip with a 3-meter length and an infrared remote that allows on-the-fly selection of colors, brightness and preset lighting effects. The flexible strip adapts to curved or angular surfaces and is suited for surface mounting in visible or hidden locations to produce accent or task lighting.

Advantages

The addressable RGB LEDs enable individual control of segments for dynamic color patterns and smooth effects. The included infrared remote simplifies operation without the need to access a software interface or internal system headers. A 3-meter length covers larger installations or multiple mounting points while the flexible construction and adhesive backing allow quick placement on most clean, dry surfaces. Brightness adjustment and multiple preset modes give control over atmosphere and visual emphasis.

Suitable for

• Interior PC case lighting and component accentuation
• Desk edge, monitor backlighting and gaming setup illumination
• Under-shelf, cabinet or display accent lighting
• Ambient room lighting for home offices, studios or entertainment areas

Key specifications

• Length: 3 metres
• LED type: addressable RGB LEDs (multi-color control)
• Control: infrared remote for color, brightness and mode selection
• Mounting: flexible strip with adhesive backing suitable for surface installation
• Power delivery: low-voltage DC operation suitable for typical LED strip power adapters or controllers

How to use

Clean the mounting surface to ensure the adhesive backing adheres securely, then peel off the protective tape and press the strip into place following the installation route. Connect the strip to a compatible low-voltage power source or controller according to the kit instructions, and use the infrared remote to power on, change colors, adjust brightness and cycle through preset modes. For curved paths, gently bend the strip along its length; avoid sharp folds. If cutting is allowed by the product design, cut only at marked points and re-seal connections to maintain electrical continuity.

Recommendations

Position the strip and remote receiver where the infrared signal has a clear line of sight for reliable control. Avoid mounting on surfaces that remain hot or exposed to moisture. Use appropriate power supplies with correct voltage and sufficient current rating for the full 3 m length to prevent dimming or overload. For extended runtime, route cables to avoid strain on soldered joints and secure the strip at regular intervals to prevent peeling.