Sieťový kábel LOGON TCR55SS100V Cat5e F/UTP (FTP) fialový 10 m RJ-45–RJ-45

LOGON TCR55SS100V Cat5e F/UTP (FTP) Purple 10 m RJ-45–RJ-45 is a 10-metre, foil-shielded networking patch cable designed for Ethernet connections in home and office environments. The cable complies with Cat5e performance parameters and uses four twisted pairs with consistent 100 Ohm impedance to support typical Fast Ethernet and Gigabit Ethernet links where shielded protection against electromagnetic interference is required. Both ends terminate in shielded RJ-45 male connectors with molded boots that provide kink protection and strain relief.

Advantages

The foil shielding (F/UTP) reduces crosstalk and external interference compared with unshielded cables, improving signal stability in electrically noisy environments. Built to Cat5e specifications with 26/7 AWG conductor construction, this patch cable offers reliable impedance matching and low signal loss over the 10 m length. Shielded RJ-45 connectors and molded boots enhance mechanical durability and maintain consistent contact quality during repeated connections and disconnections.

Suitable for

• Connecting computers, switches and routers within office or home networks
• Patching network equipment in structured cabling closets and patch panels
• Environments with potential electromagnetic interference from nearby equipment
• Temporary or permanent links between networked devices requiring shielded Cat5e cabling

Key specifications

• Cable category: Cat5e
• Shielding: Foil screened pairs, F/UTP (FTP)
• Conductor: 4 x 2, AWG 26/7 stranded
• Characteristic impedance: 100 Ohm
• Connector type: RJ-45 male — shielded on both ends
• Length: 10 metres
• Colour: Purple
• Certification level: Category 5e performance (3P Cat 5e certified)
• Features: Molded boots with kink protection and strain relief, plug-and-play

How to use

Insert each RJ-45 plug into the corresponding network port on devices such as switches, routers, patch panels or computers until the latch clicks to ensure a secure connection. Route the cable to avoid tight bends and sharp edges; use the molded boot and strain relief to reduce stress at the connector ends. For patching in racks or cabinets, allow service loops and secure the cable with Velcro or cable ties to prevent tension. No special configuration is required for standard Ethernet networks; the cable is ready for immediate use.

Recommendations

Use this shielded Cat5e cable where improved interference protection is needed compared with unshielded alternatives. Ensure proper grounding of shielded infrastructure in patch panels and outlets to obtain full shielding benefits. Avoid running network runs parallel and close to high-voltage power lines; maintain appropriate separation to minimize residual interference.