Tryska pre 3D tlačiareň Flashforge Adventurer AD3 HT 0,4 mm

Nozzle for 3D printer Flashforge Adventurer AD3 HT 0.4 mm is a replacement metal extrusion tip designed for use with Flashforge Adventurer AD3 HT machines. It provides a standard 0.4 mm aperture for general-purpose printing and is compatible with the typical filament types supported by the Adventurer AD3 HT. The nozzle is intended for routine maintenance to restore extrusion performance when the original nozzle is worn, clogged, or damaged.

Advantages

The 0.4 mm nozzle restores consistent filament flow and layer resolution for everyday prints, fits the original mounting and thread standard of the Adventurer AD3 HT, and is suitable for a range of common filament materials. Replacing a worn nozzle can reduce stringing and improve dimensional accuracy without changing printer settings.

Suitable for

• Replacing worn or damaged Adventurer AD3 HT nozzle
• Routine maintenance to maintain print quality
• General-purpose printing with PLA, ABS and other common filaments supported by the printer
• Restoring extrusion performance after clogging

Key specifications

• Model compatibility: Flashforge Adventurer AD3 HT
• Nozzle diameter: 0.4 mm
• Manufacturer part number (MPN): 20002149001
• EAN: 6971940405764
• Category: 3D printer accessory

How to use

Power off and cool the printer according to the manufacturer instructions, then remove the existing nozzle following Flashforge guidance. Install the replacement 0.4 mm nozzle by threading it into the heater block and tightening to the torque recommended by Flashforge or until seated securely without overtightening. After installation, heat the hotend and perform a test extrusion and calibration as necessary to confirm proper flow and first-layer adhesion.

Recommendations

Use suitable tools and follow Flashforge safety guidance when changing the nozzle. Periodically inspect and clean the nozzle to prolong service life; replace when wear, persistent clogging, or poor print quality cannot be corrected by cleaning. Match filament type and slicer settings to the 0.4 mm nozzle diameter for optimal results.