ALLNET G.HN Bridge konvertorová sada ALL-GHN102v2 koaxiálna point-to-point sada

The ALLNET G.HN Bridge Converter Bundle ALL-GHN102v2 Coax Point-to-Point set provides a compact solution to extend Ethernet networks over existing coaxial cabling. Designed as a paired kit, the devices use G.HN broadband powerline technology adapted for coax lines to deliver a transparent link between two locations. The set enables a quick point-to-point connection for Internet access, LAN services, IP cameras or other Ethernet devices without running new network cabling.

Advantages

This bridge converter bundle uses G.HN modulation to achieve reliable data transmission over coaxial cable while preserving the original coax infrastructure. The paired design simplifies installation by eliminating the need for additional configuration for link pairing. Compact housings and standard Ethernet interfaces make the devices compatible with existing switches, routers and endpoints. The solution reduces deployment time and cost by using already installed cabling and provides a deterministic physical layer connection suitable for Ethernet-based services.

Suitable for

• Extending an Ethernet network between two rooms or floors using existing coax cabling
• Connecting IP cameras or networked audiovisual equipment where running new cables is impractical
• Providing a point-to-point Internet or LAN uplink in apartments, offices or multi-dwelling units
• Temporary site connections or retrofit installations that require minimal physical work

Key specifications

• Technology: G.HN-based data transmission over coaxial cable
• Connection type: Point-to-point operation using paired devices
• Network interface: 10/100/1000 Mbps Ethernet ports (RJ45)
• Physical medium: Standard coaxial cable (75 ohm)
• Form factor: Compact plug-and-play units for easy placement near coax termination points

How to use

Install one unit at each end of the coax run and connect the coax cable between them. Connect the Ethernet port of each unit to the local network device such as a router, switch or IP camera using standard Ethernet cable. Power each unit according to the supplied power adapter instructions. The paired devices establish the point-to-point G.HN link automatically; verify link status using the device LEDs or management indicators and confirm network connectivity from connected endpoints.

Recommendations

For optimal performance, use a dedicated coax run between the two units and avoid sharing the same coax line with active TV splitters or attenuating devices. Ensure connectors and cable condition are good and that cable impedance matches the device requirements. Place units near existing terminations to minimize additional cabling and verify firmware and interoperability with attached network equipment where applicable.