Koaxiálny kábel ShiverPeaks 80097-32 7,5 m F-Type biely

The ShiverPeaks 80097-32 coaxial cable is a 7.5 m F-type white cable designed for transmitting RF signals between audio-video equipment, set-top boxes, satellite receivers and antenna outlets. Constructed for stable conductivity and reduced signal loss, this cable combines a standard F-type connector on each end with a length suitable for home or small office installations where a clean, unobtrusive white finish is preferred.

Advantages

This coaxial cable offers stable signal transmission and consistent impedance for television and radio frequency connections. Its 7.5 m length provides flexibility for placement while avoiding excessive slack. The white outer jacket is durable and visually unobtrusive in most interiors, and F-type connectors on both ends ensure straightforward, tool-free connection to compatible devices.

Suitable for

• Connecting TV set-top boxes and digital receivers to wall outlets or antennas
• Linking satellite receivers to LNBs or multiswitches in home installations
• Extending antenna or indoor aerial connections for radio and television
• Temporary or semi-permanent AV setups in residential and small office environments

Key specifications

• Cable type: coaxial cable with F-type connectors
• Length: 7.5 meters
• Connector gender: male F-type on both ends
• Outer jacket color: white
• Intended signals: RF for TV, satellite and radio frequency use

How to use

Connect one F-type end to the RF output of your source device (TV tuner, set-top box, satellite receiver or antenna socket) and the other end to the input on the target device or wall outlet. Hand-tighten the threaded F-type connectors until snug; avoid overtightening to prevent damage. Route the cable to avoid sharp bends and pinching and secure it with clips or cable ties where necessary to prevent strain on connectors.

Recommendations

For optimal performance, keep cable runs as short and direct as practical, use properly grounded equipment, and avoid running the coaxial cable parallel and close to power cables to reduce potential interference. Inspect connectors periodically for corrosion or looseness, and replace the cable if physical damage or degraded signal quality is observed.