LED pásik pre počítačové skrine Phanteks PH-LEDKT_M1 — univerzálna kompatibilita so skriňami, 1 ks

Phanteks PH-LEDKT_M1 is a single-piece LED strip designed for internal lighting of compatible computer cases. Supplied as one unit, the strip connects with supported Phanteks chassis to provide synchronized multicolor illumination that matches the case exterior LEDs and improves visibility inside the build during assembly and maintenance.

Advantages

The LED strip supports up to ten selectable colors and is designed to integrate with compatible Phanteks cases so that internal and exterior LEDs change together. It features a plug-and-play connector for straightforward installation and comes with double-sided 3M tape for secure mounting. The strip is described as waterproof to protect the LEDs from incidental moisture within the chassis environment.

Suitable for

• Phanteks Enthoo Luxe and Enthoo Luxe Tempered Glass chassis
• Phanteks Mini XL and Evolv ATX Tempered Glass chassis
• Phanteks Eclipse P400 and P400S, including Tempered Glass variants
• Internal case lighting for improved component visibility and cable routing during assembly

Key specifications

• Form factor: single-piece internal LED strip for computer chassis
• Color capability: multicolor with 10 selectable colors
• Mounting: double-sided 3M adhesive tape included for chassis attachment
• Connector: plug-and-play connector compatible with supported Phanteks cases
• Environmental protection: described as waterproof

How to use

Position the LED strip inside the chassis where internal illumination is required, clean the mounting surface, and secure the strip using the supplied double-sided 3M tape. Connect the strip to the case LED header or designated connector using the plug-and-play cable so that it synchronizes with the case’s external LED controls. Use the case LED switch or the compatible control interface to cycle through the ten available colors and set the desired internal lighting.

Recommendations

Install the strip on a clean, dry surface inside the case and allow the adhesive to set before moving the chassis. Verify connector alignment with the case header before applying power. For synchronized color control, connect the strip only to supported Phanteks models listed as compatible.