AOC CBO SFP+ BlueOptics BO353503J20M 10G aktívny optický kábel, 20 m

The AOC SFP+ BlueOptics BO353503J20M 10G active optical cable by BlueOptics provides a 10 Gbps connection in an SFP+ form factor over a 20-metre OM optical link. Engineered for server, switch and storage interconnects, this active optical cable reduces electromagnetic interference and weight compared with equivalent copper cables while maintaining low latency and high signal integrity. The plug-and-play SFP+ connector simplifies installation in data center and enterprise network environments.

Advantages

This active optical cable supports 10 Gbps data rates across a 20 m OM optical channel, offering lower insertion loss and improved signal stability compared with longer copper runs. The SFP+ form factor ensures compatibility with standard SFP+ ports and enables hot-pluggable deployment. As an optical solution, it reduces susceptibility to electromagnetic interference and minimizes cable bulk and weight. Its fixed-length, factory-terminated construction removes the need for on-site fiber termination and alignment.

Suitable for

• Interconnecting 10G SFP+ ports between servers and top-of-rack or aggregation switches
• High-throughput links between storage arrays and host adapters
• Short- to mid-range data center cabling where EMI immunity and reduced weight are required
• Upgrading existing copper interconnects to optical links within racks or across adjacent racks

Key specifications

• Data rate: 10 Gbps (per link)
• Form factor: SFP+ active optical cable
• Length: 20 metres (fixed)
• Fiber type: OM-class multimode optical channel
• Latency: low propagation delay characteristic of direct optical links
• Connector: SFP+ plug-and-play hot-pluggable ends
• EMI performance: immune to electromagnetic interference typical of optical transmission

How to use

Install the cable by inserting each SFP+ end into compatible SFP+ ports on network devices until the connector latches. Ensure both devices support 10 Gbps SFP+ modules and that port settings match on connected equipment. No additional transceivers or fiber patching is required because the cable is factory-terminated and active. Verify link status through the device management interface and monitor for correct link speed and error rates after installation.

Recommendations

Route the cable carefully to avoid sharp bends and mechanical strain; maintain the manufacturer’s minimum bend radius. Use cable management within racks to prevent tension on the SFP+ connectors. For optimal performance, ensure the connected ports are configured for 10G operation and that the network devices' firmware supports active optical cables of this type.