AOC kábel CBO BlueOptics BO282803L10M QSFP28 100G 10 m

Active Optical Cable CBO BlueOptics BO282803L10M QSFP28 100G 10 m is a pre-terminated QSFP28 AOC designed for native 100 Gigabit Ethernet interconnects over a 10-metre optical link. The assembly integrates QSFP28 connectors on both ends with factory-installed fiber and transceivers, enabling direct connection between compatible QSFP28 ports without separate transceiver modules. It is intended for data centre and high-performance network environments that require low latency, high bandwidth and simplified cabling for switch-to-switch, server-to-switch or aggregation links.

Advantages

The BlueOptics QSFP28 100G AOC provides high-speed 100G throughput with minimal signal conversion and reduced heat generation compared with separate transceiver+cable solutions. As a factory-terminated active optical assembly, it ensures consistent optical performance, eliminates the need for module compatibility checks and reduces installation time. Its 10 m fibre length supports flexible rack-to-rack and row interconnects while maintaining low latency and reliable transmission over short to medium distances in the data centre.

Suitable for

• Switch-to-switch connections within a data centre or equipment room
• Server-to-switch uplinks where native 100G ports are available
• Aggregation and spine-leaf topologies requiring low-latency links
• Environments preferring pre-terminated optical assemblies to simplify deployment

Key specifications

• Connector type: QSFP28 to QSFP28
• Nominal bandwidth: 100 Gigabit Ethernet (100G)
• Cable type: Active Optical Cable (factory-terminated AOC)
• Optical length: 10 metres
• Typical use distance: short- to medium-range data centre interconnects
• Latency characteristics: low latency suitable for high-performance switching
• Compatibility: designed for QSFP28 native ports (check host compatibility before deployment)

How to use

Install the QSFP28 connectors into matching QSFP28 ports on network switches, routers or servers with the device powered down or following the host vendor’s hot-plug guidelines. Verify that the host devices support QSFP28 AOC modules and native 100G operation. After insertion, confirm link status and diagnostics using the host management interface. Avoid sharp bends and mechanical stress on the AOC; route the cable to minimize strain and maintain bend radii recommended for optical assemblies. For removal, follow the host equipment procedure to prevent port damage.

Recommendations

Use this 10 m QSFP28 AOC in rack-to-rack and row interconnects within the same data hall or equipment room. For longer distances or different connector types consider transceiver plus patch-fibre solutions. Regularly inspect connectors for dust and contamination and use appropriate protective caps when ports are not in use.