Barrow silikónová ohýbacia vložka GJSGW-8 — 10 cm, biela, ohýbacia vložka pre hadice a fittingy

Barrow Silicon Bending Insert GJSGW-8 — 10 cm, white, bending insert for tubing and fittings is a 10 cm silicone shaping tool designed to support and hold soft tubing at precise curves during installation. Made from flexible silicone, the insert fits inside tubes to form consistent bends, helping to prevent kinks and maintain steady flow paths in liquid-cooling loops and other tubing systems. Its white finish allows discreet placement in visible sections, and the moderate length makes it suitable for tight routing and compact builds.

Advantages

The silicone construction provides elastic support that conforms to the inner diameter of soft tubes while preserving flexibility. By stabilizing the tube curvature, the insert reduces stress points and minimizes the risk of flow restrictions caused by accidental kinks. Its 10 cm length gives enough support for common bend radii without interfering with connectors, and the neutral white color blends with most cooling components. The insert is lightweight and easy to handle, enabling quicker, neater installations.

Suitable for

• Custom liquid-cooling loops in desktop PCs
• Tubing runs in compact or crowded enclosures
• Routing flexible tubing around tight corners and fittings
• Temporary support during installation and maintenance

Key specifications

• Material: silicone elastomer providing flexibility and shape retention
• Length: 10 cm
• Color: white
• Designed for use inside soft tubing to form controlled bends
• Compatible with standard soft tubing diameters commonly used in PC liquid cooling

How to use

Insert the silicone bending piece gently into the tube before routing. Position the insert so the supported section aligns with the intended bend, then shape the tube to the desired curve around fittings or case features. Ensure the insert does not extend into connector sealing areas; trim the tube to final length if necessary before installing clamps or compression fittings. For removal, slide the tube off the insert or withdraw the insert while supporting the tubing to avoid deformation.

Recommendations

For best results, verify compatibility with your tube inner diameter and avoid forcing the insert into undersized tubing. Use the insert during installation and reposition as needed; it can remain inside the tube during operation to maintain bend shape, but check periodically for wear or deformation when used with chemically active coolants.