CBO AOC Meraki QSFP-100G-AOC-10M 10 m aktívny optický kábel pre 100G QSFP porty

The CBO AOC Meraki QSFP-100G-AOC-10M is a 10 m Active Optical Cable designed for 100G QSFP ports, providing a plug-and-play solution for high-bandwidth connections. Built for low latency and reduced electromagnetic interference, this optical cable supports 100 Gigabit links between switches, servers and other QSFP-enabled devices. Its factory-terminated QSFP connectors simplify installation and reduce the need for field splicing or transceivers.

Advantages

This Active Optical Cable offers reliable 100G performance with minimal signal degradation over a 10 meter distance. The optical medium eliminates susceptibility to electromagnetic interference, improving signal integrity in dense rack environments. The integrated, pre-terminated QSFP connectors provide a compact, energy-efficient alternative to separate transceiver and fiber assemblies, reducing component count and easing maintenance. The plug-and-play design enables fast deployment and straightforward replacement in data center or enterprise network setups.

Suitable for

• Data center switch-to-switch interconnects
• High-speed server uplinks and top-of-rack connections
• Aggregation links in campus or enterprise networks
• Environments requiring low latency and reduced EMI

Key specifications

• Technology: Active Optical Cable (AOC) for QSFP ports
• Nominal data rate: 100 Gigabit Ethernet
• Connector type: QSFP form factor, factory-terminated
• Cable length: 10 meters
• Medium: optical fiber with integrated electronics for signal conversion
• Suitable operating environments: data center and enterprise networking racks
• Latency: low (optical transmission with integrated active components)

How to use

Install the cable by plugging each QSFP connector into compatible QSFP ports on network devices while the devices are powered according to vendor guidelines. Ensure port configurations on switches or servers match the intended 100G operation and verify link status through device management interfaces. Because the cable is pre-terminated and active, no additional transceivers or fiber patching is required. Handle the cable by its connector housings and avoid tight bends near the connector to maintain optical performance.

Recommendations

For reliable operation, use the cable within the specified 10 m length and in rack layouts that prevent excessive mechanical stress. Confirm device compatibility with QSFP 100G AOC modules and keep firmware and port settings up to date. Store and route the cable to avoid sharp bends and exposure to electromagnetic noise sources despite the optical medium.