CBO transceiver SFP-10G-BX-U 10G Single-Mode 1310nm SFP

CBO Transceiver SFP-10G-BX-U 10G Single-Mode 1310nm SFP is a 10 Gigabit SFP optical module designed for use in single-mode fiber networks at a wavelength of 1310 nm. The module provides a compact hot-swappable interface for network switches and routers, aimed at uplink and aggregation links in data center and enterprise topologies. It supports reliable 10G connectivity and straightforward installation and replacement without powering down the host device.

Advantages

This single-mode SFP transceiver delivers 10 Gigabit data rates with a 1310 nm optical interface, offering low-latency throughput suitable for high-speed uplinks. The compact hot-pluggable form factor simplifies maintenance and upgrades by allowing insertion and removal from compatible SFP cages without affecting system operation. Compatibility with standard SFP ports enables flexible deployment across multiple switch and router models used in enterprise and data center environments.

Suitable for

• 10G uplink and aggregation connections between switches and routers
• Data center server and storage interconnects over single-mode fiber
• Enterprise backbone links requiring 10 Gigabit capacity
• Network upgrades where compact, hot-swappable modules are needed

Key specifications

• Optical mode: single-mode fiber
• Nominal transmit wavelength: 1310 nm
• Data rate: 10 Gigabit Ethernet
• Form factor: SFP (small form-factor pluggable), hot-swappable
• Interface: LC duplex fiber connector compatibility
• Application: uplink and aggregation links for network switches and routers

How to use

Ensure the host device supports SFP 10G modules and that the fiber cabling is single-mode with LC connectors. With the host powered on, insert the transceiver into an empty SFP port until it seats firmly; the hot-swappable design permits installation without shutting down the system. Connect the single-mode LC fiber cable to the module, observing correct transmit/receive orientation for the link. After physical installation, verify link status via the switch or router management interface and configure network parameters as required for 10G operation.

Recommendations

Use clean single-mode LC fiber cables and inspect connectors before insertion to reduce optical loss. Match the module's 1310 nm operation to network design and verify compatibility with the host vendor's supported transceiver list where required. For optimal performance, monitor link status and error metrics after installation and follow standard electrostatic discharge handling procedures during module installation and removal.