BlueOptics SFP-10G-BX-D 10G SFP transceiver CBO jednovidový 1310nm

The BlueOptics SFP-10G-BX-D 10G SFP Transceiver CBO Single-Mode 1310nm is a compact optical module engineered for 10 Gigabit Ethernet links over single-mode fiber. Designed for use in switches, routers and optical transport equipment with SFP+ ports, this transceiver supports long-distance point-to-point and metro connections at a wavelength of 1310 nm. The module is hot-pluggable and intended for straightforward integration into existing network infrastructure to extend fiber links with minimal configuration.

Advantages

This SFP transceiver delivers 10G data rates with stable optical performance and low power consumption suitable for carrier and enterprise environments. Its single-mode design and 1310 nm wavelength enable extended reach over single-mode fiber, while the hot-pluggable form factor simplifies installation and replacement without powering down equipment. The module is compatible with standard SFP+ interfaces and is built to meet optical and mechanical interoperability expectations for network transceivers.

Suitable for

• 10 Gigabit Ethernet point-to-point fiber links
• Metro-area fiber connections between aggregation and core devices
• Upgrading SFP-enabled switches and routers to 10G single-mode links
• Optical equipment testing and maintenance requiring 1310 nm transmitters

Key specifications

• Form factor: SFP (SFP+ compatible)
• Data rate: 10 Gigabit per second
• Fiber type: Single-mode fiber
• Wavelength: 1310 nm
• Reach: designed for long-distance/metro applications over single-mode fiber
• Interface: LC connector
• Installation: Hot-pluggable

How to use

Insert the transceiver into an available SFP/SFP+ port on compatible networking equipment until it clicks into place. Connect the single-mode LC fiber patch cable to the transceiver, ensuring proper transmitter–receiver orientation. After physical installation the device should be recognized by the host port and can be configured through the switch or router management interface as required. Follow equipment vendor guidelines for link configuration, optical power budgeting and any required enabling of the port.

Recommendations

Verify compatibility with the target switch or router and confirm optical budget and distance requirements for 1310 nm single-mode fiber before deployment. Use clean LC connectors and follow standard fiber handling procedures to prevent insertion loss. For critical links, monitor link status after installation and keep a spare transceiver on hand for rapid replacement.