SFP+ aktívny optický kábel CBO Sonicwall SFP-AOC-10G-3M 10 Gbit/s, 3 m

The SFP+ Active Optical Cable CBO Sonicwall SFP-AOC-10G-3M 10 Gbps, 3 m is a factory-terminated SFP+ direct-attach solution that provides 10 Gbps full-duplex connectivity over a 3-metre active optical link. Designed for use between switches, servers and storage systems, this cable integrates transceiver electronics in the connector housings so no separate modules are required. The active optical design reduces electrical power consumption and heat compared with equivalent copper twinax assemblies while maintaining low latency and signal integrity for short-reach links in data center and enterprise networks.

Advantages

The cable delivers a compact, lightweight connection with integrated optics for plug-and-play installation into SFP+ ports, eliminating the need to handle separate transceivers and fiber patch cords. Its 3 m length is suitable for top-of-rack and adjacent-rack interconnects, offering consistent 10 Gbps throughput and lower electromagnetic interference than copper solutions. Active components in the assembly support reliable signal conditioning and longer reach than passive copper DACs while keeping system power and thermal footprint low.

Suitable for

• Short-reach connections between switches in racks and adjacent cabinets
• Server-to-switch uplinks and storage array links
• Data center patching where reduced heat and power are desired
• Environments requiring pluggable SFP+ form-factor direct optical links

Key specifications

• Interface: SFP+ form factor, hot-pluggable
• Data rate: 10 Gbps full duplex
• Length: 3 metres
• Medium: active optical cable with integrated optical transceivers
• Typical use: short-reach interconnects in racks and data centers
• Connector: SFP+ compatible duplex optical connectors integrated in cable ends

How to use

Install by inserting each SFP+ connector into the corresponding SFP+ port on your networking equipment until the retention latch engages. No separate transceivers or fiber patch cables are required. Verify link lights on both devices and confirm negotiated 10 Gbps operation via device interface or management software. For safe removal, disable the port if recommended by your equipment vendor, depress the retention latch and pull the connector straight out to avoid stressing the cable or port.

Recommendations

Ensure both endpoints support SFP+ active optical cables and compatible link speeds. Route the cable to avoid sharp bends and kinks; maintain the manufacturer's minimum bend radius to preserve optical performance. Use the 3 m length for rack-to-rack and top-of-rack connections; for longer links, select an appropriate optical transceiver and fiber type. Keep connectors clean and store with protective caps when not connected.