BlueOptics SFP+ AOC kábel SFP-AOC-10G-3M-LS-BO 10 Gbit/s, 3 m

BlueOptics SFP+ AOC cable SFP-AOC-10G-3M-LS-BO is an Active Optical Cable that provides a 10 Gbps full-duplex link over a 3-meter optical assembly. The cable uses hot-pluggable SFP+ connectors on both ends and is intended for short-reach interconnects in data center and enterprise environments. Compared with copper direct-attach alternatives, this AOC offers lower power consumption and electrical noise immunity while maintaining low latency for switch-to-switch, server-to-switch and storage networking links.

Advantages

The AOC design eliminates the need for separate transceivers and patch fiber, delivering an integrated optical connection with predictable performance. Its optical medium reduces susceptibility to electromagnetic interference and supports longer reach at the same data rate compared to copper twinax at this form factor. The hot-pluggable SFP+ interfaces allow easy replacement or reconfiguration without powering down connected equipment.

Suitable for

• Switch-to-switch uplinks in racks and across short cable channels
• Server-to-switch connections in data center top-of-rack deployments
• Storage array links requiring 10 Gbps short-reach connectivity
• High-density cabinet installations where reduced power and heat are desired

Key specifications

• Nominal data rate: 10 Gbps (full-duplex)
• Link length: 3 meters (fixed optical cable)
• Connector type: SFP+ form-factor on both ends (hot-pluggable)
• Media type: Active optical cable with integrated transceivers
• Typical use: Short-reach data center interconnects
• Electrical characteristics: lower power consumption versus equivalent copper DACs

How to use

Install the BlueOptics SFP+ AOC by inserting each SFP+ connector into compatible SFP+ ports on switches, servers or storage devices until the connector latches. No separate transceiver module or fiber patching is required. Ensure ports are rated for 10 Gbps operation and verify link status via the host device management interface. For hot-plugging, follow the equipment manufacturer’s guidance to avoid unintended traffic disruption.

Recommendations

Use the cable in short-reach top-of-rack or adjacent-rack connections where a reliable 10 Gbps link is needed and where reduced electrical interference and lower power draw are beneficial. Avoid bending the cable beyond manufacturer-recommended radii and keep connectors free of dust when not installed.