SFP+ transceiver CBO J9150AS-BO 10GBASE-R 850 nm 300 m

SFP+ transceiver CBO J9150AS-BO 10GBASE-R 850 nm 300 m is a hot-pluggable optical module designed for 10 Gigabit Ethernet short-range links over multimode fiber. It supports 10GBASE-R operation at an 850 nm wavelength and provides reliable connectivity for data center and campus network switches with compatible SFP+ ports. The module is intended for use where high-speed, short-reach multimode fiber connections are required and can be used to upgrade or replace existing transceivers to maintain network throughput.

Advantages

The transceiver offers standardized SFP+ form factor compatibility, allowing straightforward installation and hot-swap replacement without powering down equipment. Operating at 850 nm and supporting reaches up to 300 m over multimode fiber, it is suitable for typical short-range 10 Gigabit Ethernet links. The module provides consistent optical performance for aggregated server, switch-to-switch, and switch-to-storage connections while minimizing downtime during maintenance or upgrades.

Suitable for

• 10 Gigabit Ethernet links in data center server and switch interconnects
• Campus network uplinks and aggregation layers
• Short-range multimode fiber connections (up to 300 m)
• Hot-pluggable upgrades or replacements of SFP+ ports

Key specifications

• Interface: SFP+ optical transceiver
• Data rate: 10 Gbps (10GBASE-R)
• Wavelength: 850 nm
• Maximum reach: up to 300 meters over multimode fiber
• Fiber type: multimode fiber (MMF)
• Form factor: hot-pluggable SFP+ module

How to use

Insert the SFP+ transceiver into a compatible SFP+ port until it seats firmly, following the host device manufacturer’s guidance for hot-plug operations. Connect the multimode fiber patch cable with the correct connector type, verify link status on the host switch or transceiver diagnostics, and ensure proper fiber routing and strain relief. If replacing an existing module, remove the old transceiver according to the device procedure before installing the new unit.

Recommendations

Use multimode fiber with appropriate attenuation and connector quality to achieve the specified reach; verify compatibility with the host switch vendor and enable any required port settings. Handle the module by the housing, keep optical interfaces covered when not connected, and follow electrostatic discharge (ESD) precautions during installation.