SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310 nm

Hot-pluggable SFP+ transceiver CBO SFP-10G-ER-1310 provides 10 Gbps optical connectivity over single-mode fiber using a 1310 nm wavelength. The module is designed for use in compatible network equipment and enables long-reach links for data center uplinks, core switches and high-speed server connections. Its compact SFP+ form factor simplifies installation and replacement while supporting reliable 10 Gigabit Ethernet transmission.

Advantages

The transceiver delivers stable 10 Gbps throughput with low power consumption and a hot-pluggable design for minimal downtime. Using a 1310 nm wavelength and single-mode fiber compatibility, it supports extended reach connections while maintaining low bit error rates. The small form factor and standard SFP+ interface provide broad interoperability with networking hardware that supports SFP+ optical modules.

Suitable for

• Data center uplinks and inter-rack connections
• Core and distribution layer switching
• High-performance server network interfaces
• Long-reach single-mode fiber links between sites

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Form factor: SFP+ (hot-pluggable)
• Typical link reach: long-reach single-mode links (manufacturer guidance applies)
• Compatible with standard 10 Gigabit Ethernet interfaces
• Low power consumption and industry-standard electrical interface

How to use

Insert the SFP+ transceiver into an available SFP+ slot on compatible network equipment until it clicks into place. Connect a single-mode fiber patch cable to the optical port, observing correct transmit and receive alignment. Ensure the networking device is configured for a 10 Gbps optical port and verify link status through the device management interface. The hot-pluggable design allows insertion or removal without shutting down the host device, but follow your equipment vendor’s hot-swap procedures to avoid transient errors.

Recommendations

Use high-quality single-mode fiber and clean connectors to minimize signal loss; verify compatibility with your switch or transceiver vendor list before deployment and monitor link performance after installation.