SFP+ transceiver CBO SFP-10G-ZR-DE-BO — optický 10G modul 80 km

The CBO SFP-10G-ZR-DE-BO is a BlueOptics SFP+ optical transceiver module that delivers 10 Gigabit Ethernet connectivity over single-mode fiber with a transmission reach of up to 80 km. Designed for use in standard SFP+ ports, this compact module supports long-distance links required for data center interconnects, metro networks and backbone connections. The transceiver implements industry-standard form factor and optical interfaces to ensure compatibility with a wide range of switches and routers that accept SFP+ modules.

Advantages

This SFP+ transceiver provides high-speed 10 Gbps transmission combined with extended reach suitable for long-haul fiber runs. Its standard SFP+ form factor ensures straightforward installation into compatible ports without the need for adapters. The module is optimized for single-mode fiber links, offering reliable optical performance for network upgrades or extensions where increased distance and bandwidth are required.

Suitable for

• Data center interconnects and server farm links
• Metro area network links and campus backbone connections
• Long-distance point-to-point fiber links up to 80 km
• Upgrading switch and router ports to 10 Gigabit Ethernet

Key specifications

• Data rate: 10 Gigabit Ethernet (10 Gbps)
• Optical reach: up to 80 km over single-mode fiber
• Form factor: SFP+ hot-pluggable module
• Optical interface: single-mode fiber with appropriate LC connector
• Operating wavelength: designed for long-reach DWDM/CWDM-compatible wavelength (refer to device documentation for exact value)
• Power consumption: low-power SFP+ class module (refer to technical datasheet for exact numbers)
• Environmental: designed for standard commercial temperature ranges

How to use

Install the SFP+ transceiver into a compatible SFP+ port on the switch or router while the device is powered down or following the vendor's hot-swap procedure. Connect single-mode fiber with LC connectors between network devices, ensuring proper end-to-end optical cleanliness and correct polarity. After installation, verify link status and configure the corresponding port settings on the network device to enable 10 Gbps operation. Monitor optical signal levels and link integrity through device management interfaces as part of standard network operation.

Recommendations

For reliable long-distance operation, use good-quality single-mode fiber and clean LC connectors before mating. Confirm compatibility with the host device and review its supported transceiver list. When planning links close to the maximum reach, account for additional losses from splices and connectors and verify optical budget margins.