SFP+ transceiver CBO SFP10G-BX1330-BO 10 Gbit/s LC BX-D

The BlueOptics CBO SFP10G-BX1330-BO is an SFP+ optical transceiver module designed for 10 Gbit/s data transmission over single-fiber bidirectional links. With an LC connector and BX-D (bidirectional) operation, this module enables high-speed uplinks and long-distance connections while reducing fiber cabling by using a single strand for both transmit and receive channels. It is intended for installation in compatible SFP+ ports of switches, routers and media converters to extend network reach and provide reliable 10 Gbit/s connectivity.

Advantages

The module supports 10 Gbit/s line rates and BX-D bidirectional operation, allowing transmit and receive signals to share one fiber. Its LC connector and SFP+ form factor ensure compatibility with a wide range of network devices that accept standard small-form pluggable modules. The single-fiber approach reduces fiber infrastructure needs and simplifies cabling for long-distance links. The transceiver is engineered for stable optical performance to maintain signal integrity over the specified link budget.

Suitable for

• 10 Gbit/s uplinks between aggregation switches and core switches
• Long-distance point-to-point links where fiber availability is limited
• Media converters and SFP+ ports in routers and network appliances
• Fiber infrastructure upgrades that require single-fiber bidirectional solutions

Key specifications

• Form factor: SFP+
• Data rate: 10 Gbit/s
• Connector type: LC
• Transmission mode: Bidirectional (BX-D) over a single fiber
• Optical interface: Single-mode fiber
• Typical application: Uplink and long-distance point-to-point links

How to use

Insert the transceiver into a compatible SFP+ slot on a switch, router or media converter until it clicks into place. Connect an LC single-mode patch cable between modules configured for opposite wavelengths (TX and RX are reversed on the remote end) to establish a bidirectional single-fiber link. Verify link status in the device management interface and ensure that both ends are configured for 10 Gbit/s operation. Follow the host device documentation for hot-plug procedures and power-down steps if required.

Recommendations

Install matching BX transceivers at both ends of the link with correct wavelength orientation, use single-mode LC patch cords rated for the intended distance, and verify compatibility with the host device. Observe manufacturer guidelines for ESD protection and temperature limits during installation and operation.