SFP+ transceiver modul CBO X-XCVR-LR-SFP+ 10 Gbit/s 1310 nm

BlueOptics CBO X-XCVR-LR-SFP+ is an SFP+ transceiver module designed for 10 Gbit/s optical links using a 1310 nm wavelength. Intended for installation in compatible SFP+ ports, this module enables long-range single-mode fiber connections suitable for data center, enterprise switching and routing hardware. The compact form factor and standard SFP+ interface make it suitable for straightforward integration into existing network equipment that supports hot-pluggable optical modules.

Advantages

The transceiver supports a 10 Gbit/s data rate over single-mode fiber at 1310 nm, offering stable performance for long-reach links. Its SFP+ form factor provides compatibility with a wide range of switches and routers that accept industry-standard modules, and the hot-pluggable design allows installation or replacement without powering down equipment. The module is engineered for low power consumption and predictable optical performance, which helps maintain link reliability in critical networking environments.

Suitable for

Key specifications

How to use

Install the SFP+ transceiver into a compatible SFP+ port on your switch, router or transceiver-capable device while the device is powered on if the port supports hot-plugging. Connect single-mode fiber with LC duplex connectors between devices, ensuring correct transmit/receive orientation. Verify link status through the host device management interface and confirm optical parameters such as receive power and signal integrity. If necessary, consult the equipment vendor’s documentation for module compatibility and any required configuration steps such as speed or optical interface settings.

Recommendations

Use quality single-mode fiber cabling and LC duplex connectors for best performance. Confirm compatibility with the host device and keep firmware or driver notes from the equipment vendor available. Avoid exposing the optical interfaces to dust; use protective caps when the transceiver is not connected. Monitor optical power levels and link status after installation to ensure stable operation.