Transceiver CBO SFP-10G-ER BO35J15640D optické vlákno 10G

The Transceiver CBO SFP-10G-ER BO35J15640D Fiber Optic 10G is a 10G SFP+ optical module from BlueOptics designed for long-reach single-mode fiber links. It delivers a 10 Gigabit Ethernet interface suitable for uplink connections, core switch interconnects and long-distance fiber runs. The transceiver implements the extended reach (ER) optical class to support higher link budgets and longer transmission distances compared with short- and long-range modules.

Advantages

This BlueOptics SFP+ transceiver offers stable 10G throughput over single-mode fiber with ER-class reach, ensuring reliable signal integrity across extended distances. The module is hot-pluggable for easy installation and replacement in compatible SFP+ ports and supports low-latency data transmission suitable for high-performance network environments. Its form factor and optical interface follow industry standards for interoperability with compatible equipment such as LinkSys network devices.

Suitable for

• 10 Gigabit uplinks between switches and routers
• Core and aggregation layer interconnects in campus or data center networks
• Long-distance single-mode fiber links requiring ER-class range
• Fiber backbone extensions and metropolitan area fiber connections

Key specifications

• Data rate: 10 Gbps (SFP+ interface)
• Fiber type: single-mode fiber
• Optical class: ER (extended reach)
• Connector type: LC duplex
• Transmission wavelength: compatible with 10G ER optical window
• Hot-pluggable SFP+ form factor

How to use

Install the transceiver by inserting it into an available SFP+ port on a compatible switch or router until it seats securely. Connect the single-mode LC duplex fiber patch cable to the transceiver’s connector, observing transmit/receive orientation. Verify link status and speed on the network device management interface and configure port settings as needed for 10 Gigabit operation. To remove the module, power down the port if recommended by the equipment vendor or follow hot-swap procedures supported by your hardware.

Recommendations

Use quality single-mode fiber and LC duplex cables, and ensure fiber connectors are clean before insertion. Check compatibility lists for your switch or router and follow vendor guidelines for firmware and port configuration to achieve optimal 10G ER performance.