Vláknový SFP transceiver CBO SFP-1G-EX pre 1 Gbit/s pripojenia

CBO SFP-1G-EX is a fiber optic SFP transceiver module designed for 1 Gbps network links. It provides a compact hot-pluggable interface for connecting fiber equipment such as switches, routers and media converters. The module supports reliable single-mode fiber transmission for extending network reach and can be installed in standard SFP ports to enable optical uplinks without requiring major hardware changes.

Advantages

The transceiver delivers a small form factor and hot-swappable operation, allowing straightforward replacement or deployment without powering down equipment. Its single-mode fiber compatibility and support for 1 Gbps line rates ensure consistent throughput for backbone and access links. The module is compatible with common networking devices that accept standard SFP optics, enabling flexible network design and faster rollouts.

Suitable for

• Extending LAN or campus networks over single-mode fiber
• Connecting switches and routers with fiber uplinks
• Media converter links between copper and fiber segments
• Fiber backup or redundancy links for critical network paths

Key specifications

• Data rate: 1 Gbps
• Form factor: SFP (small form-factor pluggable)
• Fiber type: single-mode optical fiber
• Interface: hot-pluggable duplex optical connector
• Typical use: optical uplinks for switches, routers and media converters

How to use

Insert the SFP module into a compatible SFP slot on the network device until it clicks into place. Connect a suitable single-mode duplex fiber patch cable between the transceiver and the remote fiber port, observing correct TX/RX orientation. Configure the device port for 1 Gbps operation if required by the switch or router management interface. Monitor link status indicators on the host device to verify successful optical link establishment.

Recommendations

Use certified single-mode duplex patch cables and verify fiber connector cleanliness before installation. Avoid excessive bending of fiber cables and ensure proper port configuration on the host device. For long-distance runs, check link budgets and optical power margins specified by the network design to maintain reliable 1 Gbps operation.