Medený transceiver modul BlueOptics SFP-10G-RJ45-80M-UQ 10000 Mbit/s SFP+

The BlueOptics SFP-10G-RJ45-80M-UQ is a copper SFP+ transceiver module designed for high-speed 10 Gbit/s connectivity over standard RJ45 copper cabling. Engineered for short-range links, this single-pack module supports data transfer rates up to 10000 Mbit/s and a maximum reach of 80 metres, making it suitable for server-to-switch and switch-to-switch connections within data centres and enterprise network rooms.

Advantages

This SFP+ copper transceiver provides a compact form factor compatible with SFP+ ports and delivers reliable 10 Gbit/s performance over copper infrastructure. It reduces the need for fibre in short connections, simplifies cabling management by using familiar RJ45 interfaces, and enables fast deployment in existing network environments. The module is intended for straightforward integration with compatible networking equipment that supports SFP+ copper modules.

Suitable for

• Short-range 10 Gbit/s links in data centres
• Server-to-switch and switch-to-switch uplinks within the same room or rack
• Enterprise network segments that use RJ45 copper cabling
• Upgrading port speeds where fibre deployment is not required

Key specifications

• Interface type: SFP+
• Connector: RJ45 (copper)
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Maximum reach: 80 metres over copper cabling
• Form factor: SFP+ transceiver module

How to use

Install the transceiver by inserting the SFP+ module into a compatible SFP+ port on a switch, router, or network card until it clicks into place. Connect an appropriate Cat6/Cat6a or better RJ45 copper cable between the module and the remote device. Ensure both ends support 10 Gbit/s operation and configure link settings on network devices as required. Remove the module by releasing the latch or pull-tab and sliding it out when powering down or replacing hardware.

Recommendations

Use high-quality shielded copper cabling (Cat6a or higher) for reliable 10 Gbit/s performance and keep cable runs within the 80 metre maximum. Verify compatibility with your switch or host device documentation for supported SFP+ copper modules and apply any necessary firmware or configuration changes to enable full 10 Gbit/s operation.