Optický transceiver modul BlueOptics AXM762-10000S 10000 Mbit/s SFP+ 1310 nm

The BlueOptics AXM762-10000S 10000 Mbit/s SFP+ 1310 nm is a fiber optic transceiver module designed for high-speed point-to-point data transmission in SFP+ slots. Operating at a 1310 nm wavelength and supporting up to 10 Gbit/s (10000 Mbit/s), this module is suitable for short to medium reach fiber links in data centers and enterprise network equipment. It provides a compact form factor and standard SFP+ interface for insertion into compatible switches, routers, and host adapters.

Advantages

The module delivers a stable 10 Gbit/s optical connection at 1310 nm with a small form factor compatible with SFP+ ports. Its design focuses on interoperability with common SFP+ interfaces and straightforward installation, reducing downtime during upgrades. The transceiver supports single-channel fiber links and is suitable for environments where reliable optical connectivity and predictable performance are required.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Server-to-switch connections in data centers
• Enterprise backbone links over single-mode fiber
• Upgrading SFP+ ports for optical connectivity

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm
• Form factor: SFP+ transceiver module

How to use

Install the transceiver into an available SFP+ slot on a compatible switch, router, or network adapter until it clicks into place. Connect the appropriate single-mode fiber cable (ensure correct connector type) to the optical port and secure the cable according to equipment guidelines. Verify link status and configuration through the device management interface and configure speed/duplex or port settings as required by the host equipment. Handle the transceiver by its housing and protect the optical ports with dust caps when not in use.

Recommendations

Ensure compatibility with the host device's SFP+ interface and confirm supported link distances for 1310 nm operation. Use clean, certified single-mode fiber and follow ESD and handling procedures to avoid contamination or damage to the optical surfaces. For critical networks, test the link after installation and monitor signal/error counters through the network management system.