Optický transceiver modul BlueOptics SRX-XFP-10GE-SR-BO 10000 Mbit/s 850 nm

The BlueOptics SRX-XFP-10GE-SR-BO is an XFP form-factor fiber optic transceiver module for 10GBASE-SR networks. It supports a maximum data transfer rate of 10000 Mbit/s over multimode fiber at an operational wavelength of 850 nm and a typical reach up to 300 meters. The module is housed in a metal enclosure, has a silver finish and a compact lightweight design with a 3.3 V supply requirement, making it suitable for integration into switches, routers and storage devices that accept XFP SR transceivers.

Advantages

This transceiver implements the 10GBASE-SR short-reach specification and uses an LC duplex connector for simultaneous transmit and receive on separate fibers. It is manufactured to MSA-compatible mechanical and electrical specifications and includes digital diagnostics monitoring (DDM/DOM) support for real-time monitoring of supply voltage, laser bias current, transmit power, receive power and temperature. The compact metal housing and low weight contribute to easy handling and installation in high-density networking equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics SRX-XFP-10GE-SR-BO into a compatible XFP slot on your network device following the vendor's hot-swap and handling instructions. Connect an LC duplex multimode fiber patch cable between transceivers or to a patch panel, ensuring proper polarity for transmit and receive. Verify that the host device recognizes the module and that DDM data is available if supported by the hardware. Configure the device interfaces according to your network settings, and perform link tests to confirm signal integrity and expected throughput.

Recommendations

Use OM3/OM4 multimode fiber for reliable 10G performance at longer multimode distances and keep fiber connectors clean to maintain optimal optical power levels. Ensure the host device firmware supports third-party XFP modules and enable DDM/DOM monitoring where available for proactive diagnostics.