QSFP transceiver modul BlueOptics 02310MHR-BO 850 nm MTP/MPO 150 m

The BlueOptics 02310MHR-BO QSFP transceiver module is a 40GBASE-SR4 compatible optical module engineered for short-range high-speed data transmission over multimode fiber. It operates at an 850 nm wavelength and uses an MTP/MPO connector to support links up to 150 m. The module follows MSA QSFP form-factor standards and is suitable for use in equipment that accepts compatible QSFP transceivers. The unit is lightweight (approx. 20 g) and finished in grey.

Advantages

The transceiver provides 40 Gbit/s optical connectivity with MPO/MTP connectivity for parallel multimode fiber links, enabling simultaneous transmit and receive on multiple fibers. Compliance with QSFP MSA mechanical and electrical standards ensures interoperability with major networking hardware that supports compatible 40GBASE-SR4 optics. Digital diagnostic monitoring (DDM/DOM) is available for real-time reporting of supply voltage, laser bias current, transmit output power, received input power and module temperature when supported by the host device. The module is built using industry-standard components to provide consistent performance and long service life.

Suitable for

• 40 Gbit/s short-reach Ethernet links in data centers
• Aggregation links between switches and routers over multimode fiber
• High-speed server uplinks and storage network interconnects
• Environments requiring QSFP form-factor pluggable optics with MPO/MTP connectors

Key specifications

• Form factor: QSFP (Quad Small Form-factor Pluggable)
• Data rate: 40 Gbit/s (40GBASE-SR4)
• Wavelength: 850 nm (laser transmitter and receiver)
• Connector type: MTP/MPO multi-fiber connector
• Maximum link distance: up to 150 m over multimode fiber
• Compatibility: designed for use with hardware that supports 40GBASE-SR4 QSFP modules
• Weight: approximately 0.02 kg
• Color: grey

How to use

Insert the QSFP transceiver into a compatible QSFP port on a switch, router or other network device while the host device is powered down or following the vendor-recommended hot-plugging procedure. Connect an MPO/MTP multimode fiber patch cord to the transceiver’s connector and ensure correct fiber polarity and ribbon orientation for SR4 parallel optics. Verify link status and monitor diagnostics through the host system management interface if Digital Diagnostic Monitoring is supported. Follow the equipment vendor’s instructions for firmware or software settings required to enable third-party transceivers if applicable.

Recommendations

Use OM3/OM4 multimode fiber for reliable reach up to 150 m and maintain clean connector end-faces to avoid signal degradation. Confirm host device compatibility and, if necessary, request a test sample to validate functionality in your specific hardware and software environment.