SFP+ transceiver BlueOptics 10G-SFPP-SR-SA-BO 10000 Mbit/s 850 nm strieborná

The BlueOptics 10G-SFPP-SR-SA-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s data transmission over multimode fiber. Operating at a wavelength of 850 nm and finished in a silver housing, this compact module supports high-speed Ethernet and other optical protocols according to MSA SFP+ mechanical and electrical specifications. The transceiver is RoHS compliant and weighs approximately 20 g, making it suitable for integration into switches, routers and storage systems that accept SFP+ modules.

Advantages

The module provides 10GBASE-SR multimode operation with LC duplex connectivity, enabling simultaneous transmit and receive optical paths. It follows established MSA standards to ensure mechanical and electrical interoperability with major networking hardware. Built for low insertion effort and compact installation, the module supports digital diagnostics (DDM/DOM) where host hardware provides support, allowing monitoring of voltage, temperature, laser bias and optical power. The lightweight silver metal housing offers robust mechanical protection and helps with thermal dissipation.

Suitable for

• 10 Gigabit Ethernet links over multimode fiber
• Short-range optical connections in data centers and server rooms
• Interconnects between switches, routers and storage systems with SFP+ ports

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 850 nm
• Connector type: LC duplex (multimode fiber)
• Operating range: designed for short-range multimode links (typical up to 300 m depending on fiber type)
• Compliance: RoHS; designed to meet MSA SFP+ form-factor standards
• Weight: approx. 0.02 kg
• Enclosure color/finish: silver metal

How to use

Insert the BlueOptics SFP+ transceiver into a compatible SFP+ port until it latches, observing the correct orientation for the LC duplex connector. Connect LC multimode fiber patch cords to the transceiver’s TX and RX ports, ensuring the transmit side of one module connects to the receive side of the remote module. Verify host equipment supports DDM/DOM if diagnostic monitoring is required. Configure network interfaces in the host system as necessary and check link status indicators to confirm a successful optical link.

Recommendations

Use multimode fiber rated for 850 nm (e.g., OM3/OM4) and LC duplex patch cords for best performance. Ensure clean optical connectors and proper handling to avoid contamination. Confirm compatibility with the target switch/router firmware when using third-party transceivers, and enable DDM/DOM monitoring on supported platforms to assist with link diagnostics and maintenance.