SFP+ transceiver BlueOptics R9D81A-BO 10000 Mbit/s 850 nm

The BlueOptics R9D81A-BO SFP+ transceiver is a compact optical module designed for 10 Gbit/s multimode fiber links. It operates at an 850 nm wavelength and uses an LC duplex connector to transmit and receive optical signals. The module conforms to common MSA form-factor standards, supports a maximum data transfer rate of 10000 Mbit/s and a typical reach of up to 300 m over multimode fiber. Constructed with quality components and compliant with CE, FCC and RoHS directives, the transceiver is intended for use in switches, routers, storage systems and other network devices that accept SFP+ 10GBASE-SR modules.

Advantages

The transceiver provides 10 Gbit/s performance in a small SFP+ form factor, enabling high-density port configurations. Its LC duplex interface and multimode 850 nm optics make it suitable for short-reach data center and enterprise links. Built to industry MSA standards and populated with proven optical and electronic components, the module offers long MTBF figures and broad hardware compatibility. Compliance with relevant safety and environmental standards ensures predictable deployment in regulated installations.

Suitable for

Key specifications

How to use

Install the SFP+ transceiver into an empty SFP+ slot of a compatible switch, router or host adapter until the module clicks into place. Connect LC duplex multimode fiber patch cables to the transceiver’s LC ports, observing transmit/receive orientation. Ensure the host device firmware or driver recognizes third-party SFP+ modules and that any Digital Diagnostics Monitoring (DDM/DOM) features are supported by the host if remote diagnostics are required. Power and configure the network equipment according to the device vendor’s instructions and verify link status through the host management interface.

Recommendations

Use OM3/OM4 multimode fiber for optimal reach and signal margin at 10 Gbit/s, keep patch cables and LC connectors clean to avoid optical loss, and verify compatibility with the target hardware platform before deployment. If remote monitoring is needed, confirm that the host supports DDM/DOM to access real-time diagnostics such as optical power and temperature.