SFP transceiver modul BlueOptics ABCU-5710RZ medený 1250 Mbit/s

The BlueOptics ABCU-5710RZ Copper SFP transceiver module provides a compact, hot-pluggable interface for Gigabit networking equipment. Supporting an SFP interface and a maximum data transfer rate of 1250 Mbit/s, this module is intended to enable copper-based links between switches, routers and media converters. The module fits standard SFP ports and is compatible with devices that accept SFP copper transceivers, offering a straightforward solution for short-reach, copper Ethernet connections.

Advantages

The module's SFP form factor allows easy installation and replacement without powering down equipment. Operating over copper cabling, it removes the need for fiber in applications where copper suffices and simplifies cabling and termination. With a specified maximum data transfer rate of 1250 Mbit/s, the transceiver supports typical Fast Ethernet and some Gigabit-capable link implementations that use SFP signaling and copper media, ensuring reliable data transmission within supported network designs.

Suitable for

• Short-reach copper links between switches and routers
• Upgrading or replacing SFP copper transceivers in networking equipment
• Media converters and devices requiring an SFP copper interface
• Laboratory and testing setups for network interface validation

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Media: Copper cabling (RJ-45 compatible via module contacts)
• Maximum data transfer rate: 1250 Mbit/s
• Form factor: Hot-pluggable SFP module
• Application: Short-reach network links over copper

How to use

Insert the BlueOptics ABCU-5710RZ into a compatible SFP slot on your switch, router or media converter until it seats firmly. Connect the copper Ethernet cable to the module where applicable and ensure link/activity indicators on the host device confirm an active connection. Configure link speed and duplex settings on your network equipment if automatic negotiation does not produce the required parameters. If replacing an existing SFP transceiver, remove the old module following the device manufacturer's hot-swap instructions before installing this unit.

Recommendations

Verify that the host equipment supports copper SFP transceivers and the required link speed. Use quality copper cabling of appropriate category for the intended speed and distance, and avoid excessive bending or stress on cable runs. Handle the module by its edges and avoid touching the connector contacts; store unused modules in anti-static packaging.