SFP transceiver modul BlueOptics CSP-SFP-1WSR-BO 10000 Mbit/s

The BlueOptics CSP-SFP-1WSR-BO is an SFP+ fiber optic transceiver module engineered for 10 Gbit/s data transmission over multimode fiber. The compact, chrome-coloured module follows MSA SFP+ mechanical and electrical standards and provides a duplex LC connector for simultaneous transmit and receive operation. With a lightweight design of 20 g and support for 10 000 Mbit/s transfer rate, the module is suitable for high-speed Ethernet and Fibre Channel over short-reach multimode links.

Advantages

The module supports the 10GBASE-SR optical standard with 850 nm transmitter and receiver wavelengths, allowing multi-mode fiber connections up to typical short-reach distances. Built to MSA specifications, it offers broad compatibility with hardware that accepts SFP+ 10GBASE-SR transceivers and includes Digital Diagnostic Monitoring (DDM/DOM) support where the host device provides the interface. The compact SFP+ form factor and low weight simplify installation and service in switches, routers and storage systems.

Suitable for

• 10 Gbit/s Ethernet links over multimode fiber (short reach)
• Fibre Channel over Ethernet (FCoE) applications in data centers
• Interconnects between switches, routers and storage arrays with LC duplex ports
• Upgrading SFP+ ports to 10GBASE-SR in enterprise networks

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical standard: 10GBASE-SR (850 nm transmitter and receiver)
• Connector: LC duplex
• Compatible fiber: Multimode fiber
• Typical reach: short-reach multimode distances (300 m maximum under standard multimode conditions)
• Form factor: hot-pluggable SFP+ module
• Product colour: chrome
• Weight: 0.02 kg

How to use

Verify that the host device supports SFP+ 10GBASE-SR transceivers and that the target ports accept third-party compatible modules. Power down or follow the host vendor's hot-swap instructions if required, insert the BlueOptics CSP-SFP-1WSR-BO into an SFP+ port until it latches, and connect LC duplex multimode fiber patch cords to the transmit and receive sides. Enable or configure link settings on the connected devices as needed and check link status. If available on the host, use the DDM/DOM interface for real-time monitoring of optical parameters.

Recommendations

Use OM3/OM4 multimode fiber and high-quality LC duplex patch cords for optimal reach and performance. Ensure firmware or software compatibility on the host device to enable full functionality and DDM/DOM telemetry. For critical links, test the module in your hardware environment prior to widespread deployment.