SFP+ transceiver modul BlueOptics FA-XR2-10G-ETH-SFP-LR-BO optické vlákno LC hliník 20 g

The BlueOptics FA-XR2-10G-ETH-SFP-LR-BO is an SFP+ fiber optic transceiver module designed for 10GBASE-LR single‑mode links. It uses an LC duplex connector and an aluminium housing, and weighs approximately 20 g. The module supports bi-directional optical transmission with 1310 nm transmitter and receiver wavelengths and is built to MSA mechanical and electrical specifications for use in compatible network switches, routers, and storage systems.

Advantages

This SFP+ transceiver provides stable 10 Gbps data transmission over single‑mode fiber with a compact aluminium form factor. It follows MSA standards for broad interoperability and is engineered for long operational life and low maintenance. The module supports digital diagnostics for remote monitoring of voltage, temperature, transmit power and receive power where the host hardware exposes these features.

Suitable for

• 10 Gigabit Ethernet links over single‑mode fiber
• Connections between switches, routers and storage systems
• Data center uplinks and server to switch links
• Long‑reach optical links up to typical LR distances (single‑mode)

Key specifications

• Form factor: SFP+
• Optical mode: Single‑mode fiber
• Wavelength: 1310 nm (TX and RX)
• Connector: LC duplex
• Supported data rate: up to 10 Gbps
• Housing material: aluminium
• Weight: approx. 20 g
• Digital diagnostics (DDM/DOM) support dependent on host

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or storage device until it latches. Connect LC duplex single‑mode patch cords to the TX and RX fibers following the device documentation for TX/RX orientation. Ensure the host device firmware and interface settings match 10GBASE‑LR operation and allow for DDM if you intend to monitor diagnostics. Observe ESD precautions when handling the transceiver and keep protective dust caps on fiber connectors when not in use.

Recommendations

Verify compatibility with your hardware vendor and confirm support for third‑party transceivers to enable full functionality. Use single‑mode LC patch cords and, if monitoring is required, enable DDM/DOM in the host system. Store unused modules in anti‑static packaging and protect connector endfaces from contamination.