SFP transceiver modul BlueOptics USFP-03/M-D-R-BO 155 Mbit/s 1310 nm

The BlueOptics USFP-03/M-D-R-BO is a compact SFP fiber optic transceiver module designed for 100BASE-FX and similar optical network applications. It supports a maximum data transfer rate of 155 Mbit/s over multimode fiber at a wavelength of 1310 nm. Housed in a metal enclosure and weighing approximately 20 g, the module provides a small, durable interface with an LC duplex connector for bidirectional optical transmission up to 2,000 m according to the supported fiber type and link conditions.

Advantages

This BlueOptics SFP module adheres to MSA-compliant dimensions and connector standards, ensuring broad compatibility with networking hardware that accepts standard 100BASE-FX SFPs. The metal housing increases mechanical durability and helps with thermal dissipation. Lightweight and compact, the module is straightforward to install and replace in SFP ports. The combination of a 1310 nm transmitter/receiver and LC duplex connector enables simultaneous send and receive channels on separate fibers for stable optical links.

Suitable for

Key specifications

How to use

Power off or follow hot-swap procedures recommended by your device vendor before inserting or removing the SFP module. Align the LC connector of a compatible duplex fiber patch cord to the module’s LC ports and insert gently until it clicks. Insert the module into an available SFP slot in network equipment, ensuring the module is fully seated and the device recognizes the transceiver. Configure the host device for the intended protocol (for example 100BASE-FX or compatible Ethernet/SDH settings) and verify link status through the switch or router interface. If your hardware supports Digital Diagnostics (DDM/DOM), enable or monitor the diagnostics to observe parameters such as optical power and temperature if available.

Recommendations

Use quality multimode LC duplex patch cords and follow the manufacturer’s cleaning and handling guidelines for fiber connectors to achieve optimal range and signal quality. Confirm device compatibility with MSA-compliant SFP modules and verify whether the host device supports DDM/DOM if you require remote diagnostic monitoring.