SFP transceiver modul BlueOptics USFP-GB/S2-D-R-BO 1250 Mbit/s 1550 nm

The BlueOptics USFP-GB/S2-D-R-BO is an SFP fiber optic transceiver module designed for single-mode links with a nominal wavelength of 1550 nm and a maximum data transfer rate of 1250 Mbit/s. Housed in a compact silver QSFP28-compatible form factor and weighing approximately 40 g, this module provides a standardized optical interface for 1000BASE-EX class connections using LC duplex termination. It is intended for use in networking hardware that accepts SFP modules and supports optical transmission over extended distances on single-mode fiber.

Advantages

The module follows MSA-conformant physical and optical interfaces to ensure interoperability with a wide range of network equipment. Built with single-mode 1550 nm optics and an LC duplex connector, it supports simultaneous transmit and receive channels and is suitable for long-reach Ethernet applications up to the module's supported range. The compact SFP form factor and a modest weight facilitate easy installation and hot-swap replacement in switches, routers and other compatible devices.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP transceiver into a compatible SFP slot on the target device following the device manufacturer's hot-swap and ESD handling guidelines. Connect an appropriate single-mode LC duplex patch cord to the module's LC connector and to the remote module or patch panel. Configure the host device interface for the intended Ethernet/optical mode if required by the platform. Verify link status and, when available, monitor optical parameters via the host system to confirm proper operation.

Recommendations

Ensure the host equipment supports 1550 nm SFP modules and the desired data rate; verify compatibility with the original transceiver specification from the device vendor. Use quality single-mode LC duplex patch cords, keep optical connectors clean, and follow ESD precautions during installation. If digital diagnostic monitoring (DDM/DOM) is required, confirm that the hosting device supports that function to access real-time optical parameters.