SFP28 transceiver modul BlueOptics 980-9I595-00AM00-BO 25000 Mbit/s

The BlueOptics 980-9I595-00AM00-BO SFP28 transceiver module is a compact fiber-optic interface designed for high-speed network links. Supporting a maximum data transfer rate of 25 000 Mbit/s and a maximum reach of up to 10 000 m over single-mode fiber with an LC connector, this silver-coloured SFP28 module is intended for integration into compatible networking equipment. With an SFP28 form factor and a lightweight construction (approximately 20 g), it fits standard SFP28 ports and provides long operational life backed by a mean time between failures (MTBF) of 1 000 000 hours.

Advantages

The module offers a high data rate suitable for 25 Gigabit Ethernet environments while maintaining the compact SFP28 form factor for dense port layouts. Its LC fiber connector ensures compatibility with common single-mode fiber cabling. The silver colour and low weight simplify handling and installation, while the specified MTBF indicates long-term reliability for continuous operation. The unit is intended for straightforward hot-plug insertion into supported SFP28 ports.

Suitable for

• 25 Gigabit Ethernet uplinks and aggregation links in data centers
• Long-reach single-mode fiber connections up to 10 km
• Switches, routers or network interface cards with SFP28 ports
• Environments requiring compact transceivers for high port density

Key specifications

• Maximum data transfer rate: 25 000 Mbit/s
• Maximum transfer distance: 10 000 m (single-mode fiber)
• Form factor: SFP28
• Ethernet interface type: 2.5 Gigabit Ethernet compatible (supports 25G operation in SFP28 slot)
• Fiber optic connector: LC
• Product colour: Silver
• Weight: 0.02 kg
• Reliability (MTBF): 1 000 000 hours

How to use

Ensure the host device supports SFP28 fiber transceivers and is powered off or configured for hot-plug insertion according to the equipment manual. Remove protective caps from the LC connector and the transceiver cage before insertion. Insert the transceiver into an SFP28 slot until it latches, then connect the LC fiber patch cable. Configure the host network interface as required by the switch or router firmware, verify link status and monitor performance metrics through the management interface. To remove, power down or follow the host device hot-swap procedure, then press the release tab and pull the module straight out.

Recommendations

Use single-mode LC patch cords rated for the intended distance and maintain clean connector end-faces. Verify compatibility with the host hardware and firmware, observe ESD precautions during handling, and store the transceiver in a dust-free environment when not in use.