Sťahovacia špirála Extralink EX.30905 8 mm sklolaminátová tyč, 250 m, žltá

Extralink EX.30905 is an 8 mm fiberglass (FRP) cable pulling pilot rod, 250 m in length and finished in high-visibility yellow. It functions as a flexible, non-conductive guide for installing and routing cables through conduits, ducts and other confined pathways. The rod combines bending flexibility with axial stiffness to push or pull cables over moderate distances while resisting moisture and corrosion associated with underground and indoor installations.

Advantages

The FRP construction delivers a balance of tensile strength and flexibility, allowing the rod to negotiate bends and offsets without permanent deformation. The non-metallic, non-conductive material reduces risk near live electrical lines and eliminates issues with corrosion. At 8 mm diameter and 250 m length, the rod is lightweight for handling yet long enough for extended runs, and the yellow color improves visibility in work environments.

Suitable for

• Pulling and guiding electrical wiring through conduit systems
• Installing fiber optic and telecom cables in ducts and trays
• Routing cables in buried or indoor service tunnels and confined spaces
• Pre-installation checks and pulling fish tape replacement where a non-conductive guide is required

Key specifications

• Rod material: fiberglass reinforced plastic (FRP)
• Rod diameter: 8 mm
• Rod length: 250 m
• Color: yellow for high visibility
• Properties: flexible with axial stiffness, non-conductive, corrosion resistant

How to use

Feed the fiberglass rod through the conduit or duct by pushing from the access point until it reaches the target location. If necessary, attach a pulling eye or adapter to the end of the rod to secure the cable or a draw line, then pull the cable back through the run while guiding the rod. Use protective gloves and control the push force to avoid buckling; for longer runs work with a partner to manage rod layers and prevent kinking. After use, clean the rod of debris and store it coiled or on a reel in a dry place.

Recommendations

Inspect the pathway before use to remove sharp edges or obstacles that could damage the rod or attached cable. Do not use the fiberglass rod as a substitute for grounding or to probe live circuits. For runs with complex bends or very long distances, consider intermediate access points or a combination of push and pull techniques to reduce stress on the rod and cable.